Heating and Cooling Clinton Township

Successfully installed new Ecobee thermostat to replace existing 6-year-old unit that was malfunctioning (displaying errors and failing to shut off properly). System is now functioning correctly with thermostat showing proper temperature control settings and successfully regulating the HVAC system.

Diagnosed 5-year-old furnace in basement that was failing to maintain operation. Upon inspection, found the inducer motor and pressure switch were malfunctioning, causing the system to light briefly before shutting down. Replaced faulty components with new parts from supplier (PO:1298544-001), resolving the no-heat condition and restoring proper system functionality.

Successfully completed the deferred A/C installation, including proper connection of refrigerant lines, electrical wiring, and installation of the chimney liner. Installed and secured metal ductwork with appropriate elbow joints through the foundation wall, ensuring proper sealing at penetration points. System is now operational with all connections properly insulated and secured.

Successfully installed and reconnected a new tanked water heater in residential utility closet with proper copper pipe connections and mounting hardware. Verified all plumbing connections were secure and leak-free. System is now operational with appropriate warning labels in place regarding fire hazards and compartment usage.

Successfully completed installation of a 70,000 BTU furnace with 180-degree rotation and 500m configuration. Installation included new humidifier system and proper reconnection of all components. Mechanical permit was requested and proper drainage was established with PVC piping.

Responded to no-heat service call on 5-year-old furnace located in customer's basement. Upon inspection, found system completely non-operational with thermostat displaying red "hold" status. Diagnostic assessment of furnace components and control board revealed electrical fault preventing ignition sequence. Repaired wiring connections, reset control board, and verified proper system operation through complete heating cycle before departure.

Diagnosed and serviced 30-year-old furnace in manufactured home that had completely failed, leaving customer dependent on stove and electric heaters for warmth. Upon inspection of the mechanical room, found multiple system failures in the aging unit requiring component replacement. Successfully restored heating function and verified proper operation through thermostat testing, bringing system back to operational status.

Inspected 32-year-old G23 furnace which had completely stopped working and was emitting a burning odor. Discovered large crack in heat exchanger requiring full system replacement. Provided customer with three replacement options: furnace only, furnace/AC combination, or complete system with furnace, AC and water heater. Noted customer's interest in tankless water heater due to space constraints and possible APCO/i-wave air purification system. Documented existing Trane XE 900 outdoor unit and challenging installation access in basement location.

Responded to no-heat call for 32-year-old Lennox furnace with burning odor. Diagnosed cracked heat exchanger causing system failure, evidenced by visible fracture in combustion chamber and confirmed through visual inspection. Due to age of unit and safety concerns, recommended complete system replacement as repair not viable.

Conducted comprehensive assessment of aging HVAC system including 14-year-old furnace (basement) and AC unit (exterior). Identified plumbing issues requiring saddle valve removal and noted potential replacement of existing Goodman furnace with visible control board and wiring concerns. Documented current ductwork configuration and PVC venting system to prepare accurate replacement options.

Completed generator estimate for residential installation. Assessed existing electrical panel capacity and gas meter specifications to determine appropriate generator sizing. Documented current utility infrastructure to provide customer with comprehensive quote and installation information for a home generator system.

Successfully installed a complete HVAC system including a 110,000 BTU furnace, 4-ton air conditioning unit, and humidifier with proper ventilation. System includes S40 thermostat, 600M filter media, and APCO UV air purification system, with all components properly connected and tested. Completed installation qualifies for utility rebates and AHRI certification (#216722604).

Diagnosed 20-year-old inoperative heating unit with intermittent gas light behavior. Identified failed electrical component requiring replacement; documented part number 32004955-00 for hydrostat replacement available under existing purchase order.

Diagnosed and identified faulty pressure switch in furnace system. Confirmed proper flame operation in combustion chamber after locating replacement part (PO: 1293245-001). Verified electrical connections to ensure proper system functionality.

Performed assessment of 12-year-old air conditioning system that is still operational but showing significant signs of aging. Outdoor condenser unit exhibits visible rust on top cover and fan grill with weathered components. Documented existing electrical setup including junction box connections and meter configuration for replacement planning.

Replaced blackened condensate drain tube on 2-year-old furnace in basement. Unit is under both parts and labor warranty. Verified proper drainage and system operation after installation.

Performed Gold Boiler Inspection on 21-year-old hot water boiler located in basement. System was operational with proper pressure readings observed. Inspected plumbing connections, insulation integrity on pipes, and verified functionality of shut-off valves and control module.

Successfully installed a new 40-gallon short natural gas water heater with proper safety components including drain pan, water alarm, and new gas valve. Upgraded plumbing with cold water riser featuring ball valve, humidifier stop, and hammer arrestor. Completed chimney liner replacement with new cap installation and reconfigured 5" dryer vent for improved ventilation. Replaced furnace filter (20x25x4) as part of comprehensive service.

Responded to callback regarding intermittent power loss during furnace operation with subsequent dimming of lights. Inspected electrical panel and found no visible damage or abnormalities. Upon examination of circuit breakers and connections, determined that the electrical load from the furnace was causing voltage drop in the home's electrical system. Adjusted circuit distribution to better balance the load and prevent further power interruptions during furnace cycles.

Inspected 3-year-old combi boiler system that failed due to freezing, causing unit explosion and operational failure. Performed diagnostic evaluation of the wall-mounted system including control electronics, expansion tank, and associated plumbing components. Documented damage to recommend appropriate replacement solution, noting additional plumbing repairs needed in crawlspace that should be addressed during system replacement.