Heating and Cooling Clinton Township

Responded to no cooling call where system was running but not cooling the residence. Upon arrival, inspected outdoor condenser unit and found equipment operational with condenser fan running and compressor cycling. Verified refrigerant pressures, checked electrical connections, and confirmed proper airflow through condenser coils. System tested and returned to normal cooling operation.

Responded to service call for reduced airflow from vents and possible freezing condition on residential air conditioning system with equipment located in basement. Upon arrival, performed comprehensive diagnostic evaluation of both indoor air handler unit and outdoor condenser unit. Inspected outdoor condensing unit positioned on exterior concrete pad, verified electrical connections and proper operation of compressor and condenser fan motor. Checked refrigerant pressures and temperatures to assess system charge and identify potential restrictions or low refrigerant conditions that could cause evaporator coil icing. Examined indoor evaporator coil for ice buildup, assessed airflow across coil, and inspected air filter for restriction. Evaluated blower motor operation and static pressures to determine adequate air movement through ductwork system. Identified root cause of reduced airflow and freezing symptoms, performed necessary corrections to restore proper system operation and airflo

Responded to service call for air conditioning system experiencing intermittent operation. Upon arrival, located outdoor condenser unit at side of residence with visible accumulation of dirt, debris, and pollen on housing and coil surfaces. Inspected refrigerant lines and noted weathered copper piping with age-related tarnishing. Condenser unit displayed moderate weathering consistent with extended outdoor exposure and lack of recent maintenance. Performed visual assessment of condenser coil fins, which showed significant dust and grime buildup restricting airflow. Documented current condition of unit including debris accumulation on fan grille and housing surfaces. Unit positioned on composite pad with adequate clearance from structure. Electrical conduit and refrigerant lines inspected for obvious damage or deterioration. Recommended thorough coil cleaning and system evaluation to address intermittent operation issue and restore proper airflow efficiency.

Completed comprehensive Gold AC Inspection on residential air conditioning system with unit under 10 years old and evaporator coil located in basement. Inspected outdoor disconnect box containing Edison cartridge-style fuses, verified proper electrical connections including red, black, and green wiring through conduit fittings, and confirmed fuse holder assembly operational. Evaluated Aprilaire humidifier unit installation and associated ductwork connections. All components photographed and documented for service records.

Responded to service call for failed residential water heater. Upon arrival, assessed existing tanked water heater unit located in basement mechanical room. Unit exhibited complete failure with no hot water production. Confirmed pilot light was extinguished and burner assembly was non-operational. Inspected existing venting system consisting of metallic ductwork with proper draft configuration and insulated sections. Verified all plumbing connections including supply and discharge lines were intact. Evaluated electrical connections and gas supply lines for proper function and safety compliance. Performed diagnostic testing on thermocouple, gas valve, and ignition system. Determined water heater had reached end of serviceable life and required full replacement. Proceeded with complete water heater removal and installation of new unit. Reconnected all existing plumbing infrastructure, gas supply line, and venting system to manufacturer specifications. Tested pilot ignition, burner ope

Completed comprehensive Gold AC inspection on 10-year-old air conditioning system with air handler located in basement. Performed full system evaluation including visual inspection of HVAC equipment, verified proper operation of all components, and inspected air filtration system with 3M pleated filter in place. Advised customer that outdoor condenser area requires clearing of debris and animal waste to maintain optimal system performance and prevent future operational issues.

Performed system start-up on newly installed basement evaporator coil and air conditioning system. Utilized refrigerant manifold gauges to verify proper system pressures, superheat, and subcooling readings, confirming optimal refrigerant charge and system operation. All parameters measured within manufacturer specifications, and system commissioned successfully for cooling operation.

Completed comprehensive Gold AC inspection on 7-month-old split-system residential air conditioning unit with air handler located in basement. Performed full system evaluation of outdoor condenser unit, which was found to be in excellent working condition with clean coils, proper refrigerant line connections, and adequate clearance from debris. Advised homeowner that replacement media filter size 20x25x5 is required for continued optimal system performance.

Responded to service call for reported gas leak beneath natural gas grill. Upon inspection, located corroded galvanized gas supply line in underground utility access area showing significant deterioration with visible perforations and rust damage along pipe exterior. Traced gas line from underground chamber to above-ground connection point at wooden post where shutoff valve and brass fittings were installed. Performed pressure test on gas system to verify leak location and assess system integrity. Documented extensive corrosion on underground pipe section requiring replacement to ensure safe operation. Shut off gas supply at valve with red handle to secure system until repairs could be completed. Recommended immediate replacement of compromised underground gas line section due to safety concerns from multiple perforation points and advanced pipe deterioration.

Responded to customer complaint of hammering noise from water heater at end of heating cycle. Inspected Rheem Professional series tanked water heater located in second-level utility room. Diagnosed water hammer condition caused by thermal expansion and rapid valve closure during heating cycle completion. Verified proper operation of temperature and pressure relief valve, inspected all copper supply and discharge connections for secure mounting, and checked for loose pipe straps that could amplify vibration noise. Documented equipment condition with photographs showing unit installation, piping configuration, and connection points. Recommended installation of water hammer arrestor on hot water supply line and thermal expansion tank on cold water inlet to eliminate noise and prevent future occurrences in this 35-year-old plumbing system.

Completed comprehensive Gold AC Inspection on outdoor air conditioning unit located on exterior patio. Performed full system tune-up including inspection of electrical disconnect box, conduit connections, and unit housing. Verified proper operation of all components, checked electrical connections at disconnect panel, and documented equipment condition with photographic records showing disconnect box in open position with visible specifications panel and PVC conduit routing along exterior wall. Unit appears to be in functional condition with all exterior components properly secured and maintained.

Completed comprehensive Gold AC Inspection on a 2-year-old residential air conditioning system with air handler located in basement. Performed diagnostic testing on outdoor condensing unit using digital multimeter to verify electrical performance and system operation. Unit found to be functioning properly with no deficiencies noted during inspection.

Completed comprehensive Gold AC inspection on a two-unit residential HVAC system with equipment over 10 years old. Performed thorough evaluation of Lennox outdoor condenser unit, including inspection of fan assembly, protective wire guard, and top-discharge configuration. Verified proper operation of both units, with air handler/coil located in attic and secondary unit in basement. Inspected condenser mounting, confirmed adequate clearance around unit, and assessed overall equipment condition. All systems verified operational at time of inspection.

Completed comprehensive Gold AC inspection on 10+ year old system with outdoor condenser unit and basement-located air handler. Performed thorough examination of all electrical connections, motor assembly, wiring harnesses, and control components within air handler cabinet. Inspected outdoor condenser unit including fan operation, coil condition, and refrigerant lines. System currently operational with all components functioning as designed. Documented equipment condition through photographic records for maintenance history.

Completed routine maintenance on an 18KW Honeywell residential standby generator per manufacturer specifications. Performed comprehensive inspection of Generac model G0072260 unit, including visual examination of all major components, verification of electrical connections, and documentation of unit specifications and serial number information. System operational and functioning within normal parameters.

Completed comprehensive tune-up service on 14-year-old furnace and air conditioning system located in basement, along with hot water tank flush service. Performed full system inspection and maintenance on both heating and cooling equipment. During inspection, identified significant rust and corrosion on copper refrigerant line within AC unit, as well as rust present on internal mounting bracket in furnace compartment, indicating potential moisture exposure concerns. Documented all electrical connections, gas valve operation, and circulation pump functionality. All systems tested and confirmed operational at time of service completion.

# Outdoor Spigot Replacement Replaced two exterior hose bibs mounted on brick wall surfaces. Removed existing worn spigots and installed new frost-free sillcocks with brass adapters and shutoff valves. Addressed compromised mounting points on weathered masonry by securing fixtures with appropriate anchoring hardware. Verified proper water flow, tested for leaks at all connection points, and confirmed operational functionality of both replacement units. All plumbing connections sealed and secured to prevent future water intrusion.

Completed conversion of bathtub drain assembly from trip lever style to lift-and-turn type mechanism. Replaced existing half bath faucet with new fixture, including installation of brushed metal cross-handle faucet assembly on bathroom sink. Inspected existing shower/tub area, noting significant deterioration of fiberglass surface coating with extensive peeling and exposure of underlayer material. Verified proper operation of all new components and confirmed drainage function on both fixtures.

Completed Gold AC inspection on a 6-year-old Daikin DX13L2AF system with air handler located in basement. Unit was reported as non-operational at time of service. Performed comprehensive system evaluation including visual inspection of outdoor condenser unit, evaporator coil, and air filtration system. Documented equipment nameplate data and current operating specifications. Inspected air filter element showing pleated media in radial configuration. Captured photographic documentation of equipment condition and manufacturer identification for service records.

Completed comprehensive Gold AC Inspection and tune-up on a 4-year-old Daikin air conditioning system located in the backyard. Performed full system evaluation including refrigerant level check, electrical component testing, condenser coil cleaning, and airflow assessment. Unit is operating within manufacturer specifications with no immediate repairs needed; system is properly maintained and positioned on a stable concrete pad with adequate clearance for optimal performance.