Heating and Cooling Services in West Bloomfield Township

Completed comprehensive Gold Furnace Inspection on 4-year-old heating system located in basement. Performed full diagnostic evaluation including combustion analysis with digital manometer, recording gas pressure readings of 6.85 and 8.85 to verify proper manifold and inlet pressures. Conducted visual inspection of all system components including heat exchanger, blower assembly, electrical connections, and ductwork. Verified proper operation of all safety controls and limit switches. Checked and documented condition of wiring harnesses and electrical connections throughout cabinet. Inspected vertical supply plenums and ductwork connections for proper sealing and insulation. All components found operating within manufacturer specifications with no immediate concerns identified. System performing efficiently with no issues detected during inspection cycle. Also investigated reported water puddles in utility room near sump pump area; sump pump basin confirmed dry with no active water prese

Conducted follow-up inspection to verify no active water leaking from furnace systems and assessed any damage from previous leak incident. Confirmed the system where leak was originally identified by technician was opposite from the system where occupant initially observed leaking, with no current leakage detected from either unit and no visible water damage to surrounding areas.

Completed comprehensive Gold-level fall maintenance inspection on a 7-year-old Daikin gas furnace located in basement. Performed full system evaluation including visual inspection of heat exchanger, burner assembly, and all mechanical components. Verified proper ignition sequence and observed clean blue flame pattern with minimal orange tipping, indicating efficient combustion. Inspected blower motor assembly, electrical connections, and wiring harnesses for signs of wear or damage. Checked refrigerant lines, condensate drainage system, and all safety controls for proper operation. All components found to be functioning within manufacturer specifications. Unit is operating efficiently and ready for heating season.

Completed estimate for furnace replacement on a 20+ year-old operational unit with air handler and filtration system currently located in mechanical room. Existing system includes PVC condensate lines, insulated ductwork, and Nest smart thermostat, all functioning but equipment has reached end of expected service life and requires replacement planning.

Performed routine maintenance on a Generac emergency standby generator, model G007223I0, serial number 3016228525. Conducted comprehensive inspection of the unit, verified proper operation of all systems, and documented equipment specifications including 120/240V electrical configuration operating at 3,600 RPM. Confirmed Wi-Fi connectivity module functionality and ensured all manufacturer labels and certification markings remain intact and legible for future service reference.

Responded to report of leak under kitchen sink with suspected instant hot water dispenser as source. Upon inspection, located water heater unit in adjacent utility closet and examined all plumbing connections, including flexible supply lines and discharge piping. Documented equipment condition and connection points with photographs for service records.

# Plumbing Service - Whole Home Inspection ## Primary Concern Addressed Responded to complaint of hot water emitting sulfur/rotten egg odor. Inspected Bradford White 40-gallon natural gas water heater (Model RG240T6N, 40,000 BTU/hr input) and identified odor as likely caused by sulfur bacteria reaction with magnesium anode rod in tank. ## Water Heater Inspection Findings Examined water heater specifications and operational components. Unit displayed proper manufacturer labeling with all safety warnings intact. Verified gas input specifications and clearance requirements met code standards. Documented existing condition of tank exterior and label placement for service records. ## Whole Home Plumbing System Inspection Conducted comprehensive inspection of residential plumbing infrastructure. Examined exposed copper supply lines running vertically and horizontally through wall cavity between framing studs. Inspected multiple shut-off valves throughout system, including turquoise an

Completed Gold Furnace Inspection on a 10+ year old Lennox forced air furnace located in the basement. Unit is operational and homeowner confirmed equipment is working properly. Inspected furnace components, burners, heat exchanger, blower assembly, and safety controls per Gold maintenance protocol. Checked air filter, verified proper airflow, and tested thermostat operation. Examined venting system including PVC condensate drain lines for proper drainage and clearances. During inspection, observed a Bradford White water heater adjacent to the furnace showing signs of water leakage at the base. Noted rust-colored staining on concrete floor extending from water heater base, indicating active or recent water discharge. Visible moisture trails and corrosion present at tank base where unit meets floor. Water heater control assembly with Honeywell components shows electrical connections intact, though the brass-colored relief valve area exhibits signs of discharge. Documented conditions wi

Completed comprehensive Gold furnace inspection on two heating units located in basement, including one older 1994 model and one newer 2023 system. Performed thorough visual examination of all accessible components including gas valve assembly, electrical connections, heat exchanger, blower motor, and control modules. Utilized Milwaukee inspection camera to examine internal heat exchanger surfaces and combustion chamber areas for cracks, corrosion, or deterioration. Inspected gas valve operation, electrical relays, wiring connections, and control board functionality on both units. Noted visible corrosion on gas piping requiring future monitoring. Verified proper operation of all safety controls, ignition systems, and blower assemblies. Both furnaces confirmed operational at time of inspection with all components functioning as designed.

Responded to water leak complaint originating from ceiling. Inspected basement crawlspace and identified source of leak in copper supply line near junction with HVAC ductwork. Repaired compromised pipe fitting and verified all connections were secure. Confirmed no active leaking and advised homeowner to monitor for any recurrence.

Performed camera inspection of residential drain line in basement area as requested. Previous estimate for floor break repair had been provided during earlier visit. This inspection was unrelated to recently completed sump pump installation work. Documented basement conditions and drainage system access points for diagnostic purposes.

Responded to service call regarding propane or rotten egg odor detected near boiler exhaust pipe outside residence. Inspected 4-year-old wall-mounted boiler unit and associated hydronic baseboard heating system located in basement. Performed thorough examination of combustion chamber, heat exchanger, exhaust venting, and flue connections to identify source of gas odor. Checked all gas line connections, fittings, and valves for leaks using appropriate detection methods. Evaluated condensate pump operation and drainage system, noting customer concern about potential pump failure. Tested condensate pump functionality, inspected discharge lines, and verified proper condensate removal from boiler. Examined expansion tank, pressure relief valve, and circulating pump components. Assessed all copper piping connections and zone valves for proper operation. Verified electrical connections at control box and confirmed all safety controls functioning within manufacturer specifications. Documented

Responded to service call for sump pump system evaluation in residential basement utility area. Upon inspection, assessed existing plumbing infrastructure including vertical PVC piping with coupling connections and pressure tank assembly with copper fittings. Documented current condition of mechanical systems and surrounding area, noting wall conditions and equipment configuration for service records.

Responded to warranty callback for water backup issue following recent installation of Liberty Pumps Sump Jet water-powered backup sump pump system (Model S-110). Upon arrival, found significant basement flooding with standing water across concrete floor. Inspected sump pit installation and identified malfunction in water-powered backup system causing discharge failure. Diagnosed improper operation of backup pump mechanism, resulting in water overflow from pit during primary pump cycle. Corrected installation deficiencies, tested both primary and water-powered backup systems for proper operation, and verified adequate discharge flow. Confirmed sump pit water level maintained properly with no further backup or overflow conditions.

Installed a water-powered backup sump pump system alongside the existing primary pump to provide redundant protection against basement flooding. The installation includes new PVC discharge piping, check valves, and proper integration with the current copper supply lines and primary pump basin, ensuring automatic backup operation during power outages or primary pump failure.

Completed estimate for replacement of 10+ year old air conditioning system experiencing refrigerant leak. Current equipment operational but inefficient due to freon loss. Evaluated existing basement-installed HVAC system including natural gas furnace, ductwork, and associated plumbing components. Provided replacement options for central air conditioning unit compatible with existing furnace and air distribution infrastructure.

Responded to a non-draining sink that had been previously snaked 20 feet with no lasting results. Upon inspection, identified the issue as a sump pump drainage system with potential backup concerns in the basement utility area. Assessed the copper piping configuration, sump pump basin, and discharge lines connected to the drainage system. Cleared the obstruction and verified proper water flow through the sump pump discharge to restore full drainage functionality.

Conducted on-site evaluation for non-operational air conditioning system and hot water heater replacement estimate. Assessed existing HVAC equipment location, ductwork configuration, and utility connections including natural gas or LP fuel source availability. Documented current system conditions through photographic inspection, noting equipment access points, thermostat location, and potential installation considerations for complete system replacement. Discussed additional water filtration options with property contact to provide comprehensive estimate for multiple equipment upgrades.

Provided comprehensive estimate for complete Lennox HVAC system replacement including furnace and air conditioning unit for 20+ year old equipment currently located in basement. Existing units remain operational but have exceeded recommended service life, prompting evaluation for full system upgrade to improve efficiency and reliability.

Responded to no cooling complaint on 5-year-old residential AC system located in basement. Upon arrival, found indoor blower motor inoperative and evaporator coil frozen with ice buildup on refrigerant lines. Verified thermostat was calling for cooling and set to 80 degrees. Turned system off to allow coil to thaw completely. Inspected blower motor and found failed capacitor preventing motor operation. Replaced defective capacitor with proper OEM replacement. Once coil fully thawed, tested blower motor operation and confirmed proper airflow across evaporator coil. Checked refrigerant lines for proper insulation and verified no restrictions in ductwork. Cycled system through complete cooling cycle and monitored for proper operation. System restored to normal cooling operation with adequate airflow and no further freezing issues detected.