Heating and Cooling Services in West Bloomfield Township

Completed air conditioning system startup for newly installed basement evaporator coil. Verified proper refrigerant line connections, condensate drainage system operation with PVC piping and condensate pump, and confirmed all electrical connections to control components. System tested and operating within manufacturer specifications with adequate airflow and drainage functioning correctly.

Completed comprehensive Gold AC Inspection and tune-up on 2-year-old Lennox condenser unit. Performed full system diagnostics including refrigerant pressure checks, electrical component testing, capacitor readings, contactor inspection, and airflow verification. Cleaned condenser coils, checked drain line operation, verified proper thermostat operation, and inspected both outdoor unit and indoor air handler components. All systems operating within manufacturer specifications with no deficiencies noted.

Responded to service call for ductless mini-split system experiencing reduced cooling performance in living room/bedroom area. Performed comprehensive inspection of wall-mounted indoor unit and assessed system operation. Evaluated refrigerant levels, airflow, and overall system functionality to determine whether unit required recharging or replacement. Provided estimate for mini-split replacement options based on findings from diagnostic assessment.

Completed comprehensive Gold AC inspection on 10+ year old single unit system with basement-located air handler. Performed diagnostic testing using calibrated instruments, measuring system pressures at 106.8 psig low side and 157.2 psig high side on R-410A refrigerant. Evaluated system performance metrics including calculated superheat of 11.0°F (target 18.0°F) and subcooling of 8.1°F (target 16.0°F), indicating potential undercharge condition. Verified electrical parameters using True RMS multimeter, documenting amperage draw and voltage readings. System currently operational with homeowner present; documented all findings with diagnostic screenshots for service records.

Responded to complaint of low water level in main floor toilet that continued dropping with air bubbles present after customer returned from vacation. Inspected toilet tank and bowl assembly, identifying internal component malfunction causing water loss and air infiltration. Removed tank lid and examined flush valve, flapper assembly, and fill valve mechanism. Adjusted Fluidmaster fill valve settings and replaced defective red flapper valve that was allowing water to slowly leak from tank into bowl. Verified proper seal on flush valve seat and confirmed refill tube was properly positioned in overflow tube. Tested flush cycle multiple times to ensure proper water level restoration and elimination of air bubbles in bowl. Verified toilet now maintains consistent water level without further loss.

Completed kitchen sink plumbing repair involving the garbage disposal drain assembly and P-trap system beneath the cabinet. Inspected and serviced the connection points between the black disposal unit, white PVC P-trap, and flexible discharge hose to ensure proper drainage and eliminate leaks. Additionally, accessed the upper-level plumbing infrastructure to inspect and address copper supply line routing and support, verifying proper installation and securing of pipes within the floor joist system to prevent future issues.

Completed comprehensive Gold AC inspection on 10+ year old single-unit residential air conditioning system with air handler located in basement. Performed thorough evaluation of outdoor condensing unit positioned on composite deck adjacent to home, noting weathered condition with surface discoloration, minor rust staining on top panel, and debris accumulation including leaves and organic matter. Inspected electrical conduit runs, refrigerant line sets, and mounting stability. System confirmed operational at time of inspection. Documented equipment condition through photographic record showing exterior unit wear consistent with age and environmental exposure, including moss growth on surrounding deck surface.

Completed NSP AC inspection on single residential unit with air handler located in basement. Performed comprehensive system evaluation of outdoor condensing unit and associated components, verified proper refrigerant line installation and electrical connections, and documented equipment condition with photos. Unit found operating normally with no deficiencies noted during inspection.

Responded to service call for plumbing assessment beneath kitchen sink. Inspected dishwasher discharge line connection to garbage disposal unit and evaluated condition of shut-off valves serving sink supply lines. Examined under-sink plumbing configuration including P-trap assembly, disposal mounting, and water supply connections with braided stainless steel flex lines. Accessed crawlspace area to assess copper supply piping, support brackets, and overall condition of water distribution system serving kitchen fixtures. Documented existing plumbing infrastructure and identified components requiring replacement. Provided detailed evaluation and prepared replacement quotes for dishwasher connection line and aging shut-off valves as requested.

Completed comprehensive Gold AC inspection on 10-year-old residential air conditioning system with air handler located in basement. Performed thorough evaluation of outdoor condenser unit, which showed normal weathering consistent with age, verified fan assembly and protective grille integrity, and assessed overall system condition. Documented equipment with photographic evidence showing condenser unit positioned against exterior brick wall with minor debris accumulation at base requiring routine maintenance attention.

Performed diagnostic evaluation on 16-year-old residential furnace located in basement presenting with system malfunction error at thermostat and no heat condition. Inspection revealed failing inducer motor assembly requiring replacement. Due to advanced age of equipment and repair costs relative to system value, provided comprehensive replacement estimate for new furnace installation. Documented existing HVAC infrastructure including ductwork configuration, electrical connections, and equipment access points to facilitate accurate replacement specifications and installation planning.

Responded to service call for non-operational Lennox furnace in basement mechanical room following water intrusion from recent plumbing leak. Performed complete system inspection of furnace, ductwork, and Emerson thermostat to assess water damage and verify operational status. Documented equipment condition with photographic evidence showing furnace, air handler, and associated components in utility room setting.

Responded to no heat call with thermostat displaying system malfunction error on 8-year-old furnace located in basement. Upon arrival, performed diagnostic evaluation of heating system. Inspected gas furnace internal components including burner assembly, gas valve, and blower motor housing. Verified gas valve operation and observed burner flames igniting properly with characteristic blue flame pattern. Checked all electrical connections to gas valve including control wiring and safety circuits. Examined blower motor assembly and associated wiring harnesses for proper operation. Tested thermostat communication with furnace control board and cleared system malfunction code. Cycled system through multiple heating calls to confirm proper ignition sequence, flame sensing, and blower operation. Verified adequate airflow and proper temperature rise across heat exchanger. System restored to normal heating operation with all safety controls functioning as designed.

Completed comprehensive Gold AC inspection on 14-year-old residential cooling system with outdoor condenser unit and basement-located air handler. Performed full system evaluation including visual inspection of condenser cabinet, fan operation, electrical connections, and refrigerant lines. All components found operating within normal parameters with no immediate service needs identified at time of inspection.

Responded to a slow leak in the basement of a 40-year-old residential property. Upon inspection of the crawl space, located the source of the leak in the copper supply line system running through the floor joists. The aging copper piping showed signs of corrosion and patina consistent with the home's age. Identified a compromised joint connection that had been slowly dripping for approximately 24 hours. Repaired the affected section by replacing the faulty fitting and securing all connections. Verified the integrity of surrounding copper pipes and PVC drainage lines. Tested the system for proper water pressure and confirmed no additional leaks were present. Documented the existing plumbing infrastructure with photographs for maintenance records. The repair was completed successfully with no further water intrusion detected.

Responded to active water leak in basement originating from area above Bradford White water heater. Upon inspection, identified moisture and condensation on metallic exhaust flue pipe extending from top of water heater unit. Leak had been present for several weeks with recent worsening, contained to immediate vicinity by floor drain. Examined all plumbing connections including copper supply lines with brass fittings and dielectric union, PVC discharge piping, and surrounding utility infrastructure including yellow condensate pump and associated drainage systems. Assessed water heater installation in 1973-era home with concrete block foundation. Documented conditions with photographic evidence showing wet flue pipe, plumbing configuration, and mechanical systems layout. Confined water damage to immediate area around water heater with proper drainage preventing spread throughout basement.

Completed installation of dual 50-gallon AO Smith power vent water heaters in basement utility room. Established all hot and cold water supply connections using copper piping with proper shut-off valves, installed PVC power vent exhaust systems for both units, and completed electrical connections to code. All plumbing connections were tested for leaks, units were energized and verified operational, and system was left fully functional with proper venting configuration.

Completed comprehensive Gold AC inspection and tune-up on residential R-410A air conditioning system as part of plan membership maintenance. Performed full system evaluation including inspection of dual outdoor condensing units, verified proper leveling and placement on concrete pads, checked electrical connections and components per manufacturer wiring diagram specifications, measured refrigerant operating pressures against factory charging chart, inspected condenser coils and fan operation, and documented equipment condition with photographic records. All systems found operating within normal parameters with no immediate repairs required.

Responded to service call for hallway light fixture that was inoperative following recent furnace installation. Investigated electrical circuit and determined that wiring had been inadvertently disconnected during HVAC work. Restored proper electrical connections to wall-mounted decorative light fixture, verified operation, and confirmed all circuits functioning correctly. Fixture now operating as intended with no further issues identified.

Responded to service call for furnace malfunction. Upon arrival, performed diagnostic temperature testing at thermostat to verify system operation and temperature differential. Confirmed proper thermostat functionality and system response, restoring normal heating operation.