Heating and Cooling Services in West Bloomfield Township

Responded to service call for hallway light fixture that was inoperative following recent furnace installation. Investigated electrical circuit and determined that wiring had been inadvertently disconnected during HVAC work. Restored proper electrical connections to wall-mounted decorative light fixture, verified operation, and confirmed all circuits functioning correctly. Fixture now operating as intended with no further issues identified.

Responded to service call for furnace malfunction. Upon arrival, performed diagnostic temperature testing at thermostat to verify system operation and temperature differential. Confirmed proper thermostat functionality and system response, restoring normal heating operation.

Installed 90,000 BTU furnace with humidifier and completed all necessary electrical and mechanical reconnections. Obtained required mechanical and electrical permits for the installation. Inspected water heater and performed relighting procedure as needed to ensure proper operation of all heating systems.

Responded to basement floor drain backup near furnace area causing water accumulation. Snaked the south-side floor drain located near stairs using heavy-duty drain machine to clear blockage in the line. Successfully restored proper drainage flow, eliminating standing water issue that had been present since previous day.

Completed comprehensive Gold AC Inspection on 5-year-old outdoor condensing unit. Performed full system diagnostics including refrigerant pressure checks, electrical component testing, amperage draws on compressor and condenser fan motor, and thermostat calibration verification. Inspected condenser coils and fan assembly through protective grille, confirming proper airflow and mechanical operation. Cleaned debris from base perimeter and verified unit levelness on ground pad. All components operating within manufacturer specifications with no deficiencies identified. System ready for continued seasonal operation.

Provided estimate for installation of water supply piping from interior plumbing system to exterior location for sprinkler system connection. Assessed existing mechanical room manifold assembly and identified appropriate tie-in point at copper distribution system. Evaluated exterior routing path through foundation or wall penetration to designated outdoor termination point where third-party irrigation contractor will complete sprinkler system hookup.

Completed estimate for replacement of existing furnace in residential condo utility room with new Lennox 100,000 BTU unit. Assessed current system, including Emerson digital thermostat and electrical disconnect panel, documented equipment conditions and specifications, and provided quote for complete furnace replacement installation.

Responded to callback for boiler system not operating following previous service visit. Upon arrival, found baseboard heating system experiencing water leakage at finned tube radiator elements. Performed comprehensive diagnostic evaluation of 2-year-old water boiler system located in dining room area. Identified and addressed operational issues preventing boiler ignition sequence. Inspected all related hydronic heating components, circulator pumps, expansion tank, and zone valves. Repaired leaking baseboard fin connections and verified proper system pressurization. Tested boiler firing cycle, confirmed proper ignition, and verified adequate hot water circulation throughout all heating zones. System restored to full operational status with no further leaks detected.

Responded to service call for water leak from hot water baseboard heating fins in dining room area. Performed diagnostic inspection of 2-year-old water boiler system and associated baseboard heating components. Identified source of leak at baseboard fin connections and assessed system for proper operation and additional concerns.

Completed system start-up and commissioning of newly installed Lennox air conditioning system. Verified outdoor condenser unit is properly positioned on pad with adequate clearance, confirmed all electrical connections are secure and properly terminated at junction boxes, and tested condensate drain line for proper operation. Programmed and configured Lennox digital thermostat, verified system communication between indoor and outdoor units, and confirmed heating and cooling setpoints are functioning correctly with proper temperature readings and humidity display at 53%.

Responded to service call for foul odor emanating from shower drain. Performed mechanical snaking of drain line to remove buildup and debris causing blockage and odor. Cleared obstruction, restored proper drainage flow, and verified elimination of unpleasant smell.

# HVAC Maintenance - NSP Furnace Inspection Summary Completed comprehensive annual maintenance inspection on a 1-year-old residential furnace unit located in basement. All critical components including blower assembly, gas valve, flame sensor, igniter, and electrical connections were thoroughly examined and found to be operating within normal parameters for a unit of this age. # Detailed Service Report Performed complete NSP furnace tune-up and safety inspection on residential heating unit. Upon arrival, accessed the furnace cabinet and conducted visual inspection of all internal components. **Inspection Activities Completed:** - Examined blower assembly and motor for proper operation and secure mounting - Inspected gas valve assembly and verified all wire connections were secure - Checked flame sensor and igniter for proper positioning and condition - Evaluated all electrical wiring throughout the unit including power connections, control wiring, and safety circuits - Verified p

Addressed multiple electrical code violations including improper speed control cover installation (E3906.9), ground conductor termination issues (E3908.2/E3908.11), unsecured flexible metal conduit (E3802.1), and NM cable attachment deficiencies (E3802.3.1). Will return in spring to complete diagnosis and rewiring of low-voltage connections for air conditioning and interruptible service.

Identified and corrected mechanical violation 503.7.8 by ensuring proper 6" clearance between single wall vent pipe and combustible materials as required by table 503.10.5. Documented compliance with photographic evidence of the water heater installation and surrounding ductwork/piping configuration in the utility area.

Performed AC start-up service on Lennox outdoor condensing unit. Inspected installation placement on concrete pad, verified proper electrical connections, and confirmed adequate clearance around unit for optimal airflow. System successfully started and operating within manufacturer specifications.

Replaced defective Ecobee thermostat and PEK (Power Extender Kit) to resolve system issue where condenser unit was operating simultaneously with heating cycle. Verified proper thermostat configuration and system sequencing to ensure heating and cooling modes operate independently as designed.

Removed existing toilet and deteriorated wax ring, cleaned toilet flange area, and installed new white porcelain toilet in bathroom with proper sealing and connection to existing plumbing. Verified proper function and secure mounting to tiled floor before completing installation.

Performed Gold Furnace Inspection on 8-9 year old basement furnace. Examined all internal components including gas valve, control board, wiring connections, and heat exchanger. System is functioning properly with no immediate concerns identified.

Responded to service call regarding water stains on living room ceiling. Diagnostic inspection revealed toilet tank leaking at the bowl connection, evidenced by visible brownish water stains and mineral deposits trailing from the tank-to-bowl seal. Recommended tank-to-bowl gasket replacement and complete toilet rebuild to resolve the leak causing ceiling damage.

Performed diagnostic assessment of heating system experiencing uneven temperature distribution throughout the home. Inspected ductwork installation in attic/crawl space, identifying issues with the galvanized metal connections and airflow distribution. Evaluated hot water tank experiencing intermittent power loss during usage, which has been causing temperature fluctuations during showers for several months.