Heating and Cooling Grosse Pointe Park

Conducted estimate for furnace replacement on 15-year-old Lennox unit located in basement. Inspected existing HVAC system configuration including air handler, furnace, condensate drainage system, electrical connections, and gas lines. Documented current equipment specifications, manufacturer labels, and installation setup with photographs for replacement proposal development.

Completed annual cooling maintenance on a 7-year-old air conditioning system. Performed comprehensive AC tune-up including inspection of outdoor condenser unit, verification of proper system operation, and standard preventive maintenance procedures. System found to be operating properly with no issues identified during service visit.

Successfully completed 200 AMP electrical panel upgrade with permit coordination for comprehensive HVAC system installation. Installed new main service panel to support 70,000 BTU furnace, dual 2-ton AC units, air handler, and humidifier. Verified all electrical connections, performed system diagnostics using digital manifold gauges, and confirmed proper voltage and amperage readings across all circuits to ensure safe operation of all mechanical equipment.

# Plumbing Install - Tanked Water Heater Successfully installed a 50-gallon residential tanked water heater in the basement mechanical room. The installation included connecting copper supply lines, establishing proper venting, installing a temperature and pressure relief valve with discharge piping, and reconnecting all water supply connections to restore hot water service to the residence. All connections were pressure tested and verified for proper operation alongside the existing green boiler heating system.

Responded to complaint of AC not cooling well in basement location. Upon arrival, accessed air handler unit installed in attic space. Performed comprehensive system diagnostics using digital measurement tools to assess air side performance. Measured return air conditions showing dry bulb temperature of 62.5°F, wet bulb of 55.1°F, with relative humidity at 62.3% and dew point of 49.5°F. Supply air readings indicated dry bulb temperature of 44.7°F, wet bulb of 42.3°F, with relative humidity at 82.2% and dew point of 39.6°F. Confirmed temperature split of 17.8°F across the evaporator coil, which falls within acceptable operating parameters for proper cooling performance. Inspected air handler unit, PVC condensate drain line, and associated ductwork connections. Documented system conditions with photos showing unit installation and measurement data. System operating properly with adequate cooling capacity and airflow at time of service.

Completed Gold AC Inspection on two residential air conditioning systems - one 30-year-old unit located in basement and one unit of unknown age in attic space accessed through third-floor crawl entry. Performed comprehensive maintenance including filter inspection, refrigerant level checks, electrical connection testing, condensate drain evaluation, and airflow measurements on both systems. Basement unit inspection revealed aging copper refrigerant lines with significant green patina oxidation and corrosion buildup, indicating prolonged moisture exposure. Flexible ductwork showed heavy dust accumulation. Mineral deposits and debris observed on brass fittings and surrounding components. Documented deteriorated condition of 30-year-old system components with photographic evidence. Exterior disconnect box inspected on basement system - verified proper operation of Inverter-Duty rated disconnect switch, confirmed both line fuses operational with indicator lights functioning correctly, i

Completed full HVAC system installation including new furnace and air conditioning unit in basement utility area. Installed Ecobee 3 Lite smart thermostat for system control and programming. Ran new PVC condensate drain lines and venting, connecting to existing infrastructure with proper pitch and support. Performed pressure switch testing using digital manometer, verifying proper system pressures at 76.8 reading on both ports to ensure safe operation. Connected new ductwork with insulated trunk lines and flexible transitions. Secured all electrical connections and verified proper voltage supply. Submitted permit application and utility rebate paperwork for processing. System startup completed with all safety checks passed and equipment operating within manufacturer specifications.

Responded to urgent water heater leak in garage of 87-year-old residence. Upon arrival, found Bradford White water heater actively leaking with water being collected in bucket. Shut off water supply to unit using isolation valve to stop active leak and prevent further water damage. Inspected water heater connections, tank condition, and surrounding plumbing infrastructure. Documented equipment condition with photographs showing copper supply lines, pressure relief valve, and venting configuration. No additional leaks observed elsewhere in home during inspection.

Responded to customer report of flickering lights following recent furnace installation. Performed comprehensive electrical panel inspection and diagnostic testing using digital multimeter to identify potential issues. Examined all circuit breaker connections, wire terminations, and panel components for loose connections, improper wiring from HVAC installation, or circuit overload conditions that could cause intermittent lighting problems. Verified proper grounding, neutral connections, and circuit integrity throughout the electrical distribution system to ensure safe and stable power delivery to lighting circuits.

Replaced existing standard toilet with a new tall elongated toilet unit per customer request. Installation completed successfully with all connections properly sealed and tested for leaks. Fixtures are functioning correctly and meet current plumbing code requirements.

Successfully completed installation of Unico replacement air handler unit in basement mechanical room as part of a two-unit HVAC system upgrade. Unit was positioned on wooden subfloor with insulated flex ductwork connected and routed to ceiling distribution points, with all connections properly secured and sealed. Installation coordinated with scheduled electrical panel upgrade and appropriate permit obtained prior to commencement of work.

Completed comprehensive preventative maintenance on two furnace units and two air conditioning systems. Performed full system inspections including blower motor assemblies, electrical connections, control boards, and pressure switches. Cleaned components, verified proper operation of all safety controls, checked airflow, and ensured all wiring connections were secure throughout both heating and cooling systems.

Completed comprehensive Gold AC inspection on 26-year-old cooling system with outdoor condenser unit and basement-located air handler. Verified equipment operational status, performed standard maintenance protocols including visual inspection of condenser unit positioned against exterior brick wall, checked electrical connections and conduit routing, and assessed overall system condition. Noted vegetation growth around condenser base and weathering on unit exterior; recommended customer renew maintenance plan to include future seasonal inspections for continued system monitoring and preventive care.

Completed comprehensive Gold AC inspection on multi-unit system including one-year-old Lennox air conditioning unit and four-year-old furnace with basement coil location. Performed full system diagnostics including combustion analysis readings showing oxygen levels at 9.7%, carbon monoxide at 61 PPM, and temperature readings at 75.1°F. Inspected outdoor condensing unit confirming proper operation, clean coils, secure refrigerant lines, and overall excellent equipment condition with no visible damage or excessive wear.

Completed two-day installation of 4-ton Unico air handler coil and condenser unit in rear yard of brick residential structure. System installation included new thermostat, line flush, and reconnection of all components. Mechanical permit was obtained prior to work commencement, and all equipment was properly installed and commissioned according to manufacturer specifications.

Responded to service call for air conditioning system not cooling properly. Upon inspection, found outdoor condenser unit operational but delivering insufficient cooling capacity. Evaluated condenser coils, refrigerant lines, and electrical connections. Noted significant corrosion on outdoor disconnect and electrical terminations, which can impact system performance and efficiency. Documented equipment condition with photographs showing condenser unit exterior and corroded electrical components requiring attention. System assessed and customer advised of findings.

Responded to service call for Unico system located in attic blowing warm air. Upon inspection, identified outdoor Daikin condensing unit as the corresponding equipment. Diagnosed system malfunction, performed necessary repairs to restore proper cooling operation, and verified unit returned to normal function with adequate temperature differential.

Conducted comprehensive full system evaluation of existing Unico 5-ton HVAC system, approximately 17 years old. Performed detailed inspection of outdoor condenser unit and indoor air handling components, documenting current system condition through photographic records. Assessed exterior condenser unit mounted on brick wall exterior, noting operational wear patterns and overall equipment condition. Evaluated indoor mechanical space installation including condensate drainage system, refrigerant line routing, electrical conduit configuration, and ductwork connections. Documented aging infrastructure components and provided customer with replacement system recommendations based on equipment age and observed wear.

Completed estimate for cooling system replacement at residential property with large square footage exceeding 3000 sq.ft. Assessed existing York brand packaged air conditioning unit positioned on concrete pad adjacent to brick exterior wall. Unit evaluation included inspection of outdoor condenser with top-mounted fan assembly, refrigerant line routing along foundation, and overall system configuration for replacement planning purposes.

Completed comprehensive Gold AC Tune-Up on 5-year-old Unico air conditioning system located in attic space. Performed full system inspection including condenser unit evaluation, verified proper refrigerant levels, checked electrical connections, inspected condensate drainage, cleaned components as needed, and tested all operational parameters. Unit operating within manufacturer specifications with no deficiencies noted; system maintained and ready for continued service.