Heating and Cooling Grosse Pointe Woods

Completed comprehensive Gold Plan fall maintenance inspection on two-year-old furnace system located in basement. Performed full tune-up protocol including visual inspection of heat exchanger, burner assembly, and ignition system; tested all safety controls and limit switches; verified proper gas pressure and combustion; cleaned flame sensor; checked and documented electrical connections; inspected blower motor and wheel; replaced air filter; examined venting system and condensate drainage; tested thermostat operation and system cycling. All components found operating within manufacturer specifications with no deficiencies noted. Unit running efficiently with proper airflow and temperature rise across heat exchanger.

Completed comprehensive Gold AC and furnace inspection on 10+ year old HVAC system with equipment located in basement. Performed thorough examination of gas furnace including burner assembly, heat exchanger, gas valve, blower motor, electrical connections, and all safety controls, confirming proper operation with blue flame combustion. Inspected outdoor condensing unit including compressor, condenser coil, fan motor assembly, refrigerant lines, and electrical components, verifying adequate clearances and operational functionality. All systems operating within normal parameters at time of inspection.

Provided equipment replacement estimate for aging natural gas furnace located in basement with suspected cracked heat exchanger causing intermittent operation. Assessed existing unit configuration, ductwork connections, and available installation space to determine appropriate replacement options. Documented current system specifications and photographed equipment for proposal preparation.

Performed equipment evaluation on 21-year-old air conditioning system located in basement to provide replacement estimate. Inspected existing furnace/air handler unit showing significant dust accumulation and operational wear, along with associated ductwork and electrical components. Assessed thermostat functionality, currently operating in cooling mode and maintaining proper temperature control at 71-72 degrees. Documented equipment condition through photographs and provided homeowner with comprehensive replacement options based on system age and current state of equipment.

Completed comprehensive Gold AC inspection on 9-year-old air conditioning system and 3-year-old furnace located in basement. Performed full system evaluation including thermostat functionality check, verified White Rodgers digital thermostat displaying proper temperature readings with system operating normally. Inspected furnace unit, blower assembly, and air filtration system; noted heavy dust accumulation on cylindrical blower housing requiring attention during future maintenance. Verified air filter condition in black frame housing, checked flexible ductwork connections, and assessed overall system performance with all equipment functioning as designed at time of inspection.

Completed comprehensive city certification inspection on 10-year-old basement furnace system. Performed full tune-up including inspection of burner assembly, blower motor, gas valve, and all electrical connections. Verified proper operation of humidifier, thermostat, and hot water tank. All components found functioning within normal parameters with proper flame characteristics and airflow. System passed city certification requirements for rental property.

Completed installation of 24kW Generac standby generator with 100-amp automatic transfer switch. All electrical connections, gas line hookups, and system components were installed per manufacturer specifications and local code requirements. System was tested, commissioned, and verified operational with proper transfer switch functionality between utility and generator power.

Completed comprehensive Gold Furnace Inspection on two residential HVAC units located in basement. Performed thorough inspection of gas-fired forced air furnace, verifying proper burner ignition with characteristic blue flame pattern, examining heat exchanger integrity, testing draft inducer motor operation, and inspecting gas valve assembly and all electrical connections. Evaluated external Lennox condensing unit, confirming fan motor operation, checking refrigerant lines, and assessing overall system condition. Both units operational and functioning within normal parameters at time of inspection.

Completed comprehensive Gold-level furnace inspection on 13-year-old unit located in basement. Performed thorough examination of all internal mechanical and electrical components, including control module, gas valve assembly, blower motor, ignition system, and all associated wiring harnesses. Verified proper operation of safety controls, inspected heat exchanger for cracks or deterioration, checked all electrical connections for security and signs of overheating, and examined venting system including PVC intake and exhaust piping. Tested furnace through complete heating cycle, confirmed proper ignition sequence, flame sensor operation, and limit switch functionality. All components found operating within manufacturer specifications with no immediate safety concerns identified.

Completed Gold AC inspection on single residential unit with air handler located in basement. System is operational with homeowner reporting upstairs area warmer than downstairs during operation. Performed comprehensive inspection of outdoor condenser unit positioned on concrete pad against exterior wall, verified fan operation and examined overall equipment condition. Inspected associated water heater in basement, documented model specifications and control settings. Equipment is brand new 2025 model showing no signs of wear or operational deficiencies. All components functioning within normal parameters at time of inspection.

Responded to service call for non-functioning outdoor electrical lamppost. Upon inspection, discovered compromised wiring at the lamppost base and traced circuit back to main electrical panel. Assessed existing wiring infrastructure within wall cavity, identifying tangled and improperly organized conductors requiring attention. Evaluated lamppost fixture and underground feed wiring for damage, wear, and code compliance to determine whether repair or full replacement would be most appropriate solution.

Responded to no cooling call on 4-year-old air conditioning system located in basement. Upon arrival, found unit running continuously without cycling off as thermostat called for. Diagnosed faulty contactor that was remaining energized and preventing compressor from shutting down properly. Replaced defective contactor with new unit, restoring proper system operation and thermostat control. Tested system through multiple cooling cycles to verify unit now responds correctly to thermostat commands and shuts off when temperature setpoint is reached.

Responded to service call for leak search on HVAC system. Upon arrival, conducted thorough visual inspection of refrigerant lines, coil connections, and condensate drain system. Unable to locate active leak during initial assessment. System appears to be operating within normal parameters at time of inspection. Documented site conditions for service records. Recommend monitoring system performance and scheduling follow-up if issues persist.

Completed installation of 18kW standby generator system with 100-amp automatic transfer switch. Work included electrical connections to existing 200-amp service panel, gas pipe installation to fuel source, installation of exterior PVC conduit along brick wall for electrical wiring runs, and all associated mechanical and electrical components per code requirements. Permits were requested for mechanical, electrical, generator, gas piping, and service work, with all installations photographed for documentation and final inspection readiness.

Responded to a call for a sink that would not drain. Upon arrival, utilized a handheld drain auger with power drill attachment to clear the obstruction in the bathtub drain line. Successfully restored proper drainage and cleared the blockage.

Completed comprehensive Gold Plan AC inspection on a 5-year-old air conditioning system with air handler located in basement. Performed thorough visual inspection of HVAC equipment, including air handler unit, refrigerant lines with proper identification tags, and associated condensate drainage system. Verified all PVC condensate piping, fittings, and drain connections for proper operation and absence of leaks. Inspected electrical components, wiring, and junction boxes for secure connections and code compliance. Examined water filtration system integrated with mechanical equipment to ensure proper function. Confirmed all mechanical components, ductwork, and refrigerant lines were properly installed and maintained. Unit operating within normal parameters with no immediate service needs identified.

Completed Gold AC inspection on 12-year-old residential air conditioning system with basement-located air handler. Performed comprehensive evaluation of outdoor condenser unit, checking refrigerant levels, electrical connections, fan operation, and overall system performance. Additionally conducted generator maintenance on 5-year-old Briggs & Stratton 12kW unit; identified potential battery replacement need and forwarded equipment information to parts department for follow-up.

Responded to service call for breaker tripping issues on HVAC unit. Upon inspection, confirmed 50-amp double-pole circuit breaker was experiencing excessive heat buildup despite normal amp draw from equipment (compressor at 9.6 amps, fan motor at 1.2 amps, well below 50-amp rating). Verified all electrical connections at disconnect and unit were secure with no loose terminals or damaged conductors. Determined breaker itself was faulty and replaced defective 50-amp double-pole circuit breaker with new unit. Restored power to system and verified proper operation with no overheating conditions present.

Completed Gold AC Inspection on a 6-year-old Lennox air conditioning system with condenser unit located on exterior concrete pad adjacent to building. Performed comprehensive system evaluation including visual inspection of outdoor unit, electrical connections via PVC conduit, and proper unit placement on concrete base. All components found to be in satisfactory operating condition with no immediate service needs identified.

Provided comprehensive estimate for complete HVAC system replacement including natural gas furnace and air conditioning unit for 25-30 year old equipment located in basement. Current system is operational but has reached end of serviceable life expectancy, requiring full replacement to ensure continued reliable heating and cooling performance.