Heating and Cooling Huntington Woods

Completed comprehensive electrical estimate for residential backup generator installation. Assessed basement utility space and exterior placement options, documenting existing electrical infrastructure including exposed joists, conduit routing, and available panel capacity. Evaluated mechanical room floor space and clearance requirements for generator pad placement, noting existing HVAC ductwork and plumbing that will require consideration during installation planning.

Completed comprehensive Gold AC Inspection on 3-year-old Daikin residential cooling system. Performed full tune-up service including inspection of outdoor condenser unit, indoor air handler, electrical connections, refrigerant levels, and airflow components. All components found operating within normal parameters with no deficiencies noted. System maintaining proper operation with no corrective actions required at this time.

Responded to warranty callback for newly installed complete HVAC system experiencing freeze-up conditions immediately after initial installation. System consists of Lennox EL18KCV-036-230B04 3-ton air conditioning unit (manufactured 06/2026, serial 5826F10035) and 70,000 BTU furnace with humidifier installed in rear yard location. Inspected outdoor condenser unit, verified proper fan operation, confirmed unit mounted on concrete pad with adequate clearance. Reviewed installation specifications including 208/230V single-phase electrical connection, 7 lbs factory refrigerant charge, and AHRI certification number 216722046. Photographically documented equipment condition showing clean Lennox condenser with intact protective grille and proper exterior mounting. Addressed freezing issue through diagnostic evaluation of airflow, refrigerant levels, and system controls to restore proper operation per manufacturer specifications.

Completed comprehensive tune-up inspection on two Bryant HVAC systems (10+ years old) with air handlers located in basement and garage. Performed standard maintenance procedures on both outdoor condenser units and indoor air handling equipment, documenting blower performance data for ML180UH045E36AK and ML180UH070E36AK models. Noted significant vegetation overgrowth around exterior condenser unit requiring clearance to maintain proper airflow and system efficiency; recommended debris removal for optimal operation.

Performed routine maintenance on a 22kW Honeywell standby generator unit. Conducted comprehensive inspection of internal components, control systems, and connections. Performed maintenance reset procedure via SYNC 3.0 control panel interface, verifying proper system response and functionality of all manual and automatic operating modes.

Completed Gold AC inspection and tune-up on 1-year-old Lennox outdoor condensing unit. Performed comprehensive system evaluation including refrigerant level check, electrical connection inspection, condenser coil assessment, and fan motor operation verification. Unit operating within normal parameters with no deficiencies noted. All components functioning properly with adequate airflow through condenser coil and fan assembly. System ready for cooling season operation.

Completed full HVAC system installation including 70,000 BTU furnace and 3-ton air conditioning unit in rear yard location. Installed S40 thermostat, 600M humidifier, and reconnected existing ductwork with supply air remeasurement. Performed vacuum and refrigerant charging procedures using manifold gauges to verify proper system operation. Requested and obtained mechanical and electrical permits for installation. System qualified for utility rebates under AHRI certificate 216722046.

Completed comprehensive Gold AC inspection on 3-year-old residential HVAC system with basement-located air handler. Performed multi-point system evaluation including thermostat functionality verification, temperature differential readings, and visual equipment assessment. Thermostat operating properly with display showing 75°F set point and system responding appropriately. Inspected air handler unit and associated ductwork for proper installation, secure connections, and operational integrity. All components found in good working condition with no immediate service needs identified. Renewed maintenance plan on-site per customer request to continue coverage under Gold service agreement.

Completed full HVAC system replacement for 25-year-old equipment consisting of air conditioning unit and furnace. Installed new outdoor condensing unit on existing concrete pad with proper refrigerant line routing along exterior brick wall to new basement furnace installation. Established electrical disconnect, completed all necessary connections, and verified system operation.

Responded to loss of power in detached garage where resetting the breaker had no effect. Upon investigation, identified a failed GFCI device in the circuit feeding the garage. The GFCI showed visible corrosion on mounting hardware and failed to restore power when tested. Removed the defective GFCI, verified circuit integrity with multimeter, and replaced with new GFCI device to restore full power to the detached garage.

Completed comprehensive Gold AC inspection on 3-year-old residential air conditioning system with air handler located in basement. Performed thorough examination of outdoor condensing unit, which showed significant dirt and debris accumulation on coil surfaces and filter elements requiring attention. Inspected condenser cabinet, fan assembly with radial grille, and verified unit positioning on concrete pad with proper clearances. Evaluated electrical disconnect and conduit connections mounted on exterior wall. Assessed overall system operation and confirmed equipment was functioning at time of inspection. Documented heavy buildup of dust, dirt, and lint on front coil surfaces that could impact system efficiency and airflow if not addressed. Examined condenser coil fins through louvers and noted weathering consistent with outdoor installation. Verified fan guard integrity and checked for proper drainage around unit base. Inspected surrounding area for vegetation encroachment and debris

Completed comprehensive Gold AC Inspection on 5-year-old residential air conditioning system with air handler located in basement. Performed thorough evaluation of outdoor condenser unit, inspecting fan motor operation, refrigerant line connections, electrical components, and overall system performance. Verified proper system operation, checked refrigerant levels, cleaned condenser coils, and confirmed adequate airflow through unit. System found to be operating within normal parameters with no immediate service needs identified.

Responded to service call for reported leak under kitchen sink. Upon arrival, performed visual inspection of undermount sink basin, faucet assembly, and supply connections. Examined braided metal spray hose attachment and mounting hardware for signs of moisture or deterioration. Inspected cabinet interior beneath sink for active water intrusion, damaged supply lines, or compromised drain connections. Verified proper operation of faucet and sprayer mechanism to identify source of reported leak.

Completed annual tune-up on two five-year-old air conditioning systems. Performed comprehensive inspection of outdoor unit (model CNPVP4821ALAAAAA, manufactured February 2020) and basement unit, including refrigerant level verification, electrical component testing, condenser coil cleaning, and airflow assessment. Verified thermostat operation showing proper cooling mode function at 78°F setpoint, checked filter condition, and confirmed both systems operating within manufacturer specifications with no issues identified.

Completed comprehensive Gold AC Inspection on two exterior air conditioning units as part of routine preventive maintenance program. Performed multi-point inspection including refrigerant level verification, electrical connection testing, condenser coil cleaning, air filter evaluation, thermostat calibration, and operational performance assessment on both systems. Inspected indoor HVAC components including Bryant furnace, Aprilaire whole-home humidification system, and associated ductwork to ensure proper integration and airflow throughout the system. All equipment found operating within manufacturer specifications with no deficiencies noted; both AC units cycling properly with adequate cooling capacity and no refrigerant leaks detected.

Completed comprehensive Gold AC inspection on 2025 single-unit system with air handler located in basement. Verified system operational status at thermostat showing 72° and confirmed proper temperature control functionality. Inspected outdoor condenser unit positioned on rubber pad against exterior wall, noting adequate clearance and ventilation through louvers and top-mounted fan assembly, with minor debris accumulation around base requiring attention for optimal airflow and performance.

Responded to a toilet leaking at the base during flushing. Upon inspection, removed and reset the toilet, replaced the deteriorated wax ring seal, and reinstalled the closet bolts to ensure a proper watertight seal between the fixture and the floor flange. Tested the toilet through multiple flush cycles to verify the leak was resolved and confirmed no water discharge at the base.

Responded to no-heat call on warranty boiler located in laundry room. Upon inspection, diagnosed faulty limit switch preventing damper from opening, which disabled heating operation. Replaced defective limit switch and verified proper damper operation. Tested boiler through complete heating cycle to confirm unit restored to normal operation. Also inspected fast fill reducing valve and air vents as part of system evaluation. Unit heating properly upon departure.

Responded to no cooling complaint on 5-year-old residential air conditioning system with blower fan malfunction. Inspected basement-located equipment and outdoor condensing unit, verified thermostat settings at 72°F cooling mode, and documented system configuration. Diagnosed blower motor failure preventing air circulation through the system, resulting in complete loss of cooling capacity.

Completed comprehensive cooling system inspection on 3-year-old residential air conditioning unit. Performed standard maintenance protocol including visual inspection of outdoor condenser unit positioned on concrete pad with proper clearance, verified refrigerant line connections at air handler in basement showing normal patina on copper piping, confirmed all components operational and system cooling effectively. Unit found in good working condition with no immediate service needs identified.