Heating and Cooling Huntington Woods

Conducted on-site evaluation for installation of flexible water supply line with shutoff valve in basement area for basic sink setup. Assessed exposed ceiling with accessible plumbing lines in finished basement entertainment space. Determined optimal routing for water line connection and valve placement to accommodate future rudimentary sink installation. Provided estimate for materials and labor required to complete installation.

Completed comprehensive AC inspection on multi-unit residential system with 4-year-old Daikin equipment. Inspected outdoor condenser units positioned in landscaped area with mulch bedding, verified proper fan operation, checked refrigerant lines and electrical connections, and documented equipment condition with protective grilles intact and functioning normally. Air handler/coil located in basement was assessed, and all components found to be operating within normal parameters with no immediate service needs identified.

Completed Gold AC inspection on residential cooling system with outdoor condensing unit and basement air handler. Performed comprehensive evaluation of equipment operation, verified system functionality, and conducted visual inspection of condenser unit positioned on pad against exterior brick wall. Delivered complimentary air filter as part of Gold maintenance program, confirmed unit operating properly with clean, well-maintained exterior surfaces and proper clearances from surrounding landscaping.

Completed estimate for replacement of 13-year-old residential air conditioning system experiencing no cooling condition with warm air discharge. System evaluation revealed failed outdoor fan motor and defective contactor on exterior AC unit positioned on concrete pad adjacent to brick structure. Indoor air handler and furnace located in basement utility area showed signs of age-related wear consistent with 10+ year-old equipment requiring full system replacement consideration.

Completed comprehensive Gold AC inspection on 10+ year old air conditioning system with air handler located in basement. Performed thorough evaluation of outdoor condenser unit, inspecting fan assembly, blades, motor components, and housing condition. Verified proper operation of cooling system, examined condenser coil cleanliness, checked refrigerant levels, tested electrical connections, and assessed overall equipment performance. Noted condenser fan blades and housing in good condition with minimal debris accumulation. Advised customer to maintain clear area around outdoor unit, removing any debris and animal waste to ensure proper airflow and system efficiency. Documented equipment condition through photographic inspection showing clean fan assembly, secure mounting hardware, and well-maintained exterior components. System operational and functioning within normal parameters at time of inspection.

Responded to no cooling complaint on 10+ year old AC unit located in basement. Upon inspection, found blower wheel assembly operational but discovered significant rust and corrosion buildup inside condensate drain line, indicating long-term moisture accumulation and potential drainage issues. Documented equipment condition with photos showing blower assembly in clean operational state and severely corroded PVC drain pipe interior. Advised property owner of findings and recommended drain line cleaning and system evaluation to prevent future drainage problems that could lead to water damage or system shutdown.

Conducted on-site evaluation of existing 32-year-old air conditioning system located on exterior side of residence to provide replacement estimate. Inspected current outdoor condensing unit and assessed overall system condition, noting equipment age has exceeded typical service life expectancy. Evaluated interior HVAC components including ductwork assembly, furnace unit with access panels, and associated mechanical connections in basement utility area. Documented existing system configuration through photographic records showing dark-colored metal ductwork, cylindrical pipe connections, and furnace equipment with transparent inspection panels. Reviewed current installation layout to determine replacement specifications and equipment requirements for new air conditioning system installation.

Completed comprehensive Gold AC inspection on a 5-year-old residential air conditioning system with air handler located in basement. Performed thorough examination of outdoor condenser unit, including fan assembly, motor hub, and protective grille, confirming all components were in functional condition with normal outdoor exposure wear. Inspected system operation, verified proper airflow through fan blades, and assessed surrounding area clearance to ensure optimal performance and efficiency of the cooling system.

Completed Gold AC Inspection on 4-year-old single-zone residential air conditioning system with air handler located in basement. Performed comprehensive maintenance inspection including visual assessment of outdoor condensing unit, refrigerant line connections, and overall system operation. Addressed customer concern regarding condenser unit settlement and slope deterioration since installation. Inspected unit positioning on mulch bed alongside brick exterior, noting condensing unit placement and ground conditions. Evaluated structural stability, refrigerant line routing along exterior wall, and proper drainage considerations. Photographically documented current condenser positioning, surrounding landscape conditions, and unit installation configuration for future reference. Verified system operational status, inspected condenser coil fins, fan assembly with protective grille, and electrical connections. Confirmed proper refrigerant line insulation and secure mounting to building ex

Completed non-service plan air conditioning inspection on a 10-year-old residential cooling system with air handler located in basement. Unit was operational at time of inspection, exterior condenser showed normal wear consistent with age, and all accessible components were documented through photographic records including manufacturer data plate showing R-410A refrigerant specifications and model information.

Responded to service call for Mitsubishi mini-split system with one outdoor condenser and three indoor wall-mounted units reporting warm air discharge from all zones. Upon arrival, performed visual inspection of outdoor unit located on concrete pad in backyard and indoor evaporator units installed in bedrooms and living room. Conducted system diagnostics to identify cause of insufficient cooling. Checked refrigerant pressures, electrical connections, and thermostat settings across all zones. Verified proper operation of outdoor condenser fan and compressor. Inspected indoor units for airflow restrictions and proper mounting. System restored to normal cooling operation following diagnostic procedures and minor adjustments.

Responded to service call for non-operational Bryant humidifier system located in basement. Upon inspection, diagnosed failed water supply motor preventing proper water distribution to humidifier pad. Motor showed no electrical continuity and was unable to pump water through supply line to humidification assembly. Replaced defective water supply motor with OEM equivalent component, reconnected water supply tubing and electrical connections, and verified proper operation of humidifier system integrated with existing HVAC ductwork.

Completed comprehensive Gold AC Inspection and tune-up service on two 14-year-old air conditioning systems—one basement unit and one upstairs unit. Performed thorough system evaluation on both indoor air handlers and outdoor condensers, including inspection of blower motor assemblies, fan components, electrical connections, and refrigerant lines. Removed access panels to examine internal components, verified proper operation of all mechanical systems, and checked condensate drainage. Inspected outdoor condenser units positioned on brick patio area, evaluating fan grilles, protective mesh housing, refrigerant line connections, and electrical conduit routing. Both systems demonstrated normal operational parameters for units of this age and received preventive maintenance to ensure continued reliable performance throughout the cooling season.

Responded to a commercial property for a garbage disposal experiencing intermittent leaking and operational issues. Upon inspection, examined the 1/2 HP disposal unit mounted under the kitchen sink, including all connection points, drain lines, and electrical components. Verified power supply and confirmed circuit breaker was in the on position, then assessed the disposal's mounting flange, discharge plumbing, and dishwasher drain connection for signs of leakage or loose fittings.

Completed Gold AC Inspection on a 6-year-old single-unit air conditioning system with air handler located in basement. Performed comprehensive maintenance inspection of outdoor condenser unit and verified system operational status, with all components functioning properly at time of service.

# Plumbing Repair Completed Responded to service call for under-sink plumbing concerns. Upon inspection, discovered significant condensation accumulation on galvanized supply pipes beneath bathroom fixture, indicating potential temperature differential issues or inadequate ventilation. Photographically documented existing pipe assembly configuration, including chrome shut-off valve connections and mounting hardware. Assessed attic space above service area to identify any contributing factors, noting exposed framing, fiberglass insulation placement, and utility routing. Verified all threaded connections were secure and properly sealed. Ensured proper drainage function and confirmed no active leaks present in the supply line assembly.

Completed comprehensive Gold AC inspection on 7-year-old residential cooling system with air handler located in basement. Performed multi-point inspection of outdoor condensing unit including visual assessment of fan assembly, grille condition, and mounting hardware. Verified proper clearance around condenser unit with debris-free perimeter, confirmed operational status of system components, and documented equipment condition through photographic records showing normal wear patterns consistent with unit age.

Responded to service call for multiple plumbing concerns throughout the residence. Replaced external valve and associated outside piping to restore proper water flow and eliminate leakage. Addressed small bathroom sink equipped with four individual valves, performing necessary replacements to ensure proper operation and shutoff capability. Disassembled and rebuilt shower mixer valve assembly, replacing worn internal components including cartridge, seals, and O-rings to restore proper temperature control and eliminate cross-flow issues. Investigated kitchen sink drainage problem with reduced flow rate. Upon inspection, identified corroded P-trap assembly with significant mineral buildup and verdigris formation on metal components. Removed deteriorated metal trap sections and replaced with new PVC drain assembly to improve drainage performance and prevent future leaks. Documented existing conditions through photographs showing underside of floor structure near plumbing access points an

Completed comprehensive boiler inspection at basement location. Performed combustion analysis using digital diagnostic meter, recording oxygen levels at 20.8%, carbon monoxide at 0 ppm, pressure at 0.04, and flue temperature at 32.9°F. Inspected internal heat exchanger components, evaporator coils, and electrical connections including capacitor and wiring harness; all components found to be in operational condition with no immediate safety concerns identified.

Completed full HVAC system installation including 70,000 BTU furnace, 3-ton rear-discharge air conditioning unit with AHRI certification #215664802, humidifier, and liner. Installed 40-gallon hot water heater with pump and reconnected all necessary utilities. Performed pressure switch testing using diagnostic equipment, confirming proper system operation with readings of 6.76 and 6.86 inWC. Installed exterior PVC condensate drainage lines through brick exterior wall with proper termination and grading. Obtained mechanical and electrical permits for all installed equipment, and system qualifies for applicable utility rebates.