Heating and Cooling Clawson

Completed comprehensive Gold Furnace Inspection on an 8-year-old forced air heating system located in basement. Performed thorough examination of all major components including gas valve assembly, burner tubes, blower motor, electrical connections, and wiring harnesses. Inspected gas line connections, verified proper operation of all safety controls, and documented equipment condition with detailed photography showing internal components and current system status. Unit is operating properly with all components functioning within normal parameters.

Responded to service call for gurgling noise coming from 2017 forced air furnace located in basement. Performed comprehensive inspection of heating system following previous repairs. Utilized Fieldpiece SC680 true RMS clamp meter to verify electrical readings and system performance. Measured incoming line voltage at 239 VAC, confirming proper power supply to unit. Tested amperage draw on system components, recording 10.2 amps during operation, which falls within normal operating parameters for equipment of this age and type. Inspected all accessible ductwork, condensate drainage system, and heat exchanger for potential sources of unusual sounds. Checked for proper condensate trap water level and drainage flow, as gurgling noises commonly originate from condensate system issues. Verified all electrical connections were secure and properly terminated. System operational at time of departure with no abnormal sounds detected during testing cycle.

Completed annual hot water boiler inspection and tune-up on a 1-year-old 96,000 BTU/h natural gas unit located in utility room. Verified operational status of control board with digital display reading 165°F, inspected all electrical connections and wiring harnesses, and examined gas valve assembly and manifold components. All safety controls, warning labels, and AHRI-certified specifications confirmed in proper working order with no deficiencies noted.

Completed prepaid maintenance inspection on a 2-year-old gas furnace located in basement. Performed comprehensive system evaluation including visual inspection of all internal components, blower motor assembly, heat exchanger, gas valve connections, venting system, and electrical wiring. All components found to be operating within normal parameters with no immediate service needs identified.

Completed comprehensive Gold-level furnace inspection on a 1-year-old forced air system located near the back door. Performed thorough examination of all furnace components including inducer fan motor, burner assembly, gas valve, ignition system, and electrical connections with all wiring harnesses verified for proper installation and function. Removed access panel to inspect internal components, confirmed proper operation of blower motor assembly, verified gas valve connections and all colored wire terminations secure, and documented equipment condition with photographic records. All burner tubes, safety controls, and ventilation components including flue pipe connections inspected and found to be operating within manufacturer specifications with no deficiencies noted at time of inspection.

Completed full electrical service upgrade including installation of new main electrical panel in basement utility area. Removed existing outdated service equipment and installed modern circuit breaker panel with proper load distribution across multiple branch circuits. Established new main breaker assembly with appropriate amperage rating, installed individual circuit breakers in organized configuration, and completed all necessary electrical connections using code-compliant wiring methods. Ensured proper grounding and bonding throughout the system, verified all circuits for correct operation, and confirmed safe installation in accordance with current electrical codes. System tested and operational.

Completed comprehensive Gold AC Inspection on a 1-year-old outdoor air conditioning system. Performed full system evaluation including visual inspection of condenser unit, verified proper operation of fan assembly and motor, checked electrical connections and disconnect, inspected refrigerant lines and housing for damage or deterioration, and confirmed unit is functioning correctly with no visible defects or maintenance concerns noted.

Responded to service call for central air conditioning system with reduced cooling capacity. Upon arrival, located Bryant brand condenser unit positioned against building exterior with overgrown vegetation restricting airflow around unit. Cleared debris and plant material from base and sides of condenser to restore proper ventilation and prevent efficiency loss. Performed electrical diagnostics using digital multimeter to verify system voltage, amperage draw, and component functionality. All electrical readings confirmed within manufacturer specifications with no detected abnormalities. Conducted thorough leak check of refrigerant system including condenser coil, service ports, and line connections - no leaks detected. System operating properly with adequate cooling output restored following vegetation clearance and diagnostic verification.

Completed comprehensive electrical inspection of residential basement electrical panel and associated wiring systems. Evaluated panel condition, circuit loading, wire routing through floor joists, and proper securing of conductors with appropriate fasteners. Assessed conduit connections, grounding systems, and overall code compliance of the electrical installation in the unfinished basement utility area.

Completed comprehensive Gold AC inspection on 6-year-old Daikin outdoor condenser unit located on exterior concrete pad. Performed full system evaluation including visual inspection of cabinet condition, refrigerant lines, electrical connections, and fan assembly. Unit found to be in clean, functional condition with no visible damage, deterioration, or immediate service concerns noted during inspection.

Responded to service call for non-operational air conditioning unit with reported unusual noise and visible wiring damage. Upon arrival, inspected 23-year-old outdoor condensing unit and identified severely deteriorated electrical connections with exposed and damaged wiring at the contactor assembly. Found evidence of arcing and heat damage at wire terminals, along with significant corrosion on metal components throughout the unit due to age and weather exposure. Documented hazardous electrical conditions with photographs showing frayed wires and compromised connections that posed safety risk. Unit was deemed unsafe for operation and customer was advised to shut down system immediately to prevent potential electrical fire or further equipment damage. Recommended complete electrical component replacement and full system evaluation given the age of the equipment and extent of deterioration observed.

Completed comprehensive Gold AC preventive maintenance inspection on a 4-year-old residential outdoor condensing unit. Performed full system evaluation including refrigerant pressure checks, electrical component testing, condenser coil cleaning, and verification of proper airflow through the top-mounted fan assembly. All components operating within manufacturer specifications with no deficiencies noted.

Completed prepaid maintenance inspection on 1-year-old Lennox residential air conditioning system. Performed comprehensive evaluation of outdoor condensing unit and indoor basement coil assembly. Unit found in excellent operational condition with no deficiencies noted at time of service.

Completed comprehensive Gold AC Inspection and tune-up on an 11-year-old outdoor air conditioning unit located in backyard. Performed full system evaluation including inspection of condenser unit, fan assembly, and protective grille which showed normal age-related wear with accumulated dirt and debris. Cleaned condenser coils, checked refrigerant levels, tested electrical connections, verified proper airflow through fan assembly, and ensured all components were operating within manufacturer specifications. Unit is functioning properly and ready for continued seasonal use.

Completed comprehensive Gold AC inspection on 2010 HVAC system with air handler located in basement. Performed thorough evaluation of all system components including ductwork, refrigerant lines, electrical connections, and condensate drainage system. Advised customer to maintain clear area around outdoor condenser unit, removing any debris and animal waste to ensure proper airflow and system efficiency.

Performed no-charge estimate for laundry room plumbing fixtures. Assessed existing valves and faucet configuration, documented current conditions with photos, and provided replacement recommendations for scheduling upcoming installation. Parts ordered and available for pickup under purchase order at supply house.

Completed full HVAC system installation including a Lennox 70,000 BTU furnace (Model CK40CT-24B-71) utilizing R-454B refrigerant, 2.5-ton air conditioning unit, whole-home humidifier, and 40-gallon short water heater with recirculation pump. Installed Sensi smart thermostat, performed all necessary ductwork connections, and reconnected existing equipment in rear yard location. Submitted permit application and processed utility rebate applications with Consumers Energy and DTE Energy, with AHRI certification number 215584593 documented for compliance verification.

Completed comprehensive assessment of existing HVAC system utilizing R22 refrigerant for full system replacement estimate. Evaluated indoor air handler unit located in basement utility area and documented current equipment configuration, including furnace assembly, PVC condensate drainage system, and associated ductwork. Inspected outdoor condensing unit mounted on exterior brick wall near building foundation, noting electrical connections and drainage components. Provided detailed equipment replacement recommendations due to obsolete R22 refrigerant system, including specifications for modern high-efficiency heating and cooling equipment compatible with current environmental standards.

Performed routine inspection and tune-up on a 2023 Daikin ductless mini-split cooling system. Inspected indoor wall-mounted evaporator unit and outdoor condensing unit, verified proper airflow through both components, and confirmed system operational status. All components found to be functioning within normal parameters with no issues identified at time of service.

Completed comprehensive Gold AC Inspection and tune-up on a 7-year-old Bryant air conditioning system located behind the residence. Performed full preventive maintenance protocol including inspection of condenser unit, cleaning of coils, verification of refrigerant levels, testing of electrical components, and assessment of overall system performance. Unit was found to be in good operational condition with no issues identified during the inspection.