Heating and Cooling Lake Orion

Responded to service call for routine AC maintenance on a 20-year-old outdoor air conditioning unit. Upon arrival, confirmed system was operational but had not received scheduled preventive maintenance since a previous repair visit. Performed comprehensive tune-up inspection including evaluation of outdoor condenser unit located in utility access area beneath deck structure, assessed thermostat operation showing 82°F display reading, and documented equipment condition through photographic records. System evaluated for replacement consideration due to age and provided estimate for new equipment installation.

Completed comprehensive Gold AC Tune-Up on 20-year-old Quantum outdoor condenser unit. Performed full system inspection, cleaned condenser coils, checked refrigerant levels, tested electrical connections, verified proper airflow through fan assembly, and ensured unit operational efficiency. Unit operating within normal parameters upon completion; customer advised of system age and recommended monitoring for future replacement considerations.

Completed comprehensive Gold AC seasonal inspection on outdoor condenser unit located behind residence. Performed full system evaluation including refrigerant level check, electrical component testing, condenser coil cleaning, and airflow assessment. Unit operating within normal parameters; all safety controls verified and system prepared for cooling season operation.

Returned to complete boiler piping repair to address active system leak. Tightened 1-1/4" union connection at circulator pump using appropriately sized wrench and performed soldering work at top of circulator pump to seal leaking joints. System tested and verified leak-free operation upon completion.

Completed comprehensive Gold AC inspection on 5-year-old residential air conditioning system. Performed thorough examination of outdoor condensing unit, confirming proper operation of all components. Inspected electrical disconnect, refrigerant line set, and condensate drainage system. Verified unit is functioning correctly with no immediate service needs identified. Checked cabinet condition, fan assembly, and protective grille. Documented equipment condition with photographs showing unit positioned on exterior pad with proper clearances maintained. All safety labels present and legible. System operating within normal parameters at time of inspection.

Completed comprehensive Gold AC inspection on 6-year-old residential HVAC system with air handler located in basement. Performed full system evaluation including inspection of Aprilaire humidifier unit, ductwork connections, and associated plumbing components. Verified proper operation of all equipment, examined copper refrigerant lines with reflective insulation, checked humidifier water supply line and control panel functionality, and documented system condition through photographic records. Provided complimentary air filter as part of gold-level maintenance service.

Completed comprehensive Gold AC Inspection on residential HVAC system with equipment less than 10 years old and air handler/coil located in basement. Performed thorough evaluation of all system components, including inspection of Honeywell humidistat control mounted on equipment panel, verified proper dial settings and operational status. Documented AO Smith ProLine XE commercial grade water heater with top-mounted circulator pump assembly, inspected associated piping connections and verified system integration. Advised customer that condenser area must be maintained clear of debris and animal waste for optimal performance and system longevity.

Completed full HVAC system installation including a 90,000 BTU furnace and 3.5-ton Lennox air conditioning unit positioned on the right side of the residence. Obtained mechanical and electrical permits prior to installation, installed outdoor condenser on concrete pad with proper refrigerant line routing and electrical connections, reconnected all system components, and verified proper operation of complete heating and cooling system.

Completed comprehensive Gold AC Inspection on a 4-year-old Lennox air conditioning system. Performed full system tune-up including inspection of outdoor condenser unit, verified proper operation of compressor and condenser fan motor, checked refrigerant levels and pressures, cleaned condenser coils, inspected electrical connections and contactors, tested capacitor performance, and evaluated overall system performance. Unit is properly positioned on concrete pad with adequate clearance and drainage, showing normal operational condition with no deficiencies noted at time of service.

Completed comprehensive Gold AC Inspection on a 6-year-old Lennox air conditioning system with air handler located in basement. Performed full system evaluation including condenser unit inspection, verified proper operation of outdoor unit with fan grille and louvered cabinet panels, checked electrical connections and disconnect boxes mounted on exterior wall, confirmed unit is properly mounted on concrete pad with adequate clearance, and verified surrounding area is clear of debris with mulch landscaping maintained appropriately. System is operating as designed with no deficiencies noted during inspection.

Responded to leak complaint on recently installed hot water boiler system located in lower level. Upon inspection, identified two primary issues: loose 1-1/4" union connection at circulator pump requiring proper torque with appropriately sized wrench, and insufficient solder joint at top of circulator pump. Photographic documentation captured moisture accumulation on copper piping and brass fittings, confirming active leak points. Tightened accessible union connection; however, soldering materials were not available on service vehicle at time of visit. Noted that 1-1/4" union and soldering supplies are available at shop for completion of repairs. Equipment is approximately four months old, showing signs of condensation and minor corrosion on brass components due to ongoing leak condition. Additional service visit required to complete solder joint repair at circulator pump connection.

Responded to no cooling complaint on 20-year-old outdoor AC unit. Performed diagnostic evaluation using testing equipment to assess system performance and identify failure points. Due to the advanced age of the equipment and extent of required repairs, recommended system replacement as the most cost-effective solution for restoring reliable cooling operation.

Completed installation of a 50-gallon power vent water heater in residential utility closet. Unit was properly positioned, all water supply lines and gas connections were secured, power vent exhaust system was installed and verified for proper operation, and system was tested to ensure safe and efficient functionality.

Completed comprehensive Gold AC inspection on 4-year-old single residential cooling system with air handler located in basement. Verified White Rodgers programmable thermostat operation at 74 degrees with proper temperature control functionality. Inspected outdoor condensing unit positioned on rubber pad with river rock landscaping, confirmed proper installation with copper refrigerant lines, insulated linesets, electrical disconnect, and adequate clearances for airflow and serviceability.

Responded to tankless water heater service call following HVAC technician assessment. Replaced three-quarter inch copper piping components including pro press 90-degree fitting, 45-degree fitting, and coupling with approximately 12 inches of new three-quarter inch pipe. Installed new tankless water heater isolation valves to ensure proper system operation and maintenance access. Brought tankless flush kit on-site and offered descaling service to homeowner. Upon inspection, verified water quality conditions were favorable with minimal scale buildup observed on related equipment. Tested all connections for leaks, confirmed proper valve operation, and verified system functionality upon completion.

Responded to service call for leaking State Select water heater installed in 2014 located in readily accessible lower level utility area. Upon inspection, confirmed active leak contained to immediate heater area with no significant water damage to surrounding spaces. Evaluated unit condition, age (11 years), and extent of leak to determine repair feasibility versus replacement recommendation. Documented existing installation including copper supply lines, pressure relief valve configuration, and current plumbing connections. Provided assessment and recommendations to address the leak issue based on unit age and condition.

Responded to water leak concern at tankless water heater installation. Upon inspection, discovered significant rust and corrosion around pipe connections, fittings, and brass components at the pressure relief valve assembly. The unit, approximately one year old, showed premature deterioration at threaded connections and elbow joints. Documented corrosion patterns on copper and brass fittings, particularly around the pressure relief valve with red handle and associated piping. Photographed affected areas showing oxidation on metallic surfaces and compromised pipe joints that could lead to future leak points if left unaddressed.

Completed on-site electrical estimate for natural gas quick connect installation to accommodate portable generator. Assessed existing utility space including gas line routing, electrical conduit pathways, and available connection points in mechanical area. Reviewed generator specifications and documentation to determine proper quick connect sizing and placement requirements for safe and code-compliant installation.

Installed new 40-gallon PV hot water tank with proper PVC ventilation. Connected all plumbing components with appropriate fittings and verified secure installation of the vent pipe assembly to exterior wall. System tested and functioning correctly with no leaks detected.

Diagnosed non-functioning baseboard heating system on 5-year-old boiler unit located in utility closet. Inspected heat exchanger connections, pressure regulator valve, and associated copper piping. Identified and repaired faulty electrical connections to restore proper heating function.