Heating and Cooling Redford

Completed sump pump replacement in basement utility area. Removed existing failed unit and installed new sump pump system with PVC discharge piping. Verified proper operation and drainage function. Inspected basement plumbing infrastructure and provided estimate for relocating toilet from upper level to lower level, including recommendation for high-pressure flush toilet installation to accommodate potential drainage challenges.

Performed routine preventive maintenance inspection on sump pump system in residential basement. Conducted comprehensive assessment of pump operation, float switch functionality, and discharge line integrity. Inspected basin for proper water level, sediment accumulation, and debris. Verified electrical connections and tested pump cycle to ensure proper activation and shutoff. Checked discharge piping for secure mounting and confirmed absence of leaks or blockages. All components found operating within normal parameters with no repairs required at this time.

Responded to complaint of loud noise from 2-month-old AC unit while system continued to operate and cool properly. Performed diagnostic evaluation of outdoor condensing unit, including electrical measurements using clamp meter which indicated 7.3 amp draw. Inspected compressor, condenser fan motor, and associated electrical components for abnormal operation or mechanical issues that could generate excessive sound levels.

Conducted on-site evaluation for furnace replacement in residential basement. Assessed existing Rheem furnace unit, approximately 50 years old, with pale yellow cabinet showing surface discoloration and wear consistent with age. Documented current system configuration including metal supply ductwork, flexible return ducts, and existing venting arrangement. Evaluated mechanical room layout with water heater proximity and available clearances for new equipment installation. Provided comprehensive replacement quote for modern high-efficiency furnace system to replace aging unit that has exceeded its typical service life expectancy.

Conducted comprehensive assessment for whole-house HVAC system replacement, evaluating existing 26-year-old furnace located on first floor near rear of residence and determining requirements for new central air conditioning installation where none currently exists. Inspected electrical panel capacity and wiring configuration to verify adequate power supply for new heating and cooling equipment, photographed existing electrical infrastructure including circuit breaker arrangement and available connections to ensure proper system integration during installation phase.

Provided comprehensive estimate for complete central air conditioning system replacement at owner-occupied residence. Existing outdoor condenser unit, approximately 20 years old and located in backyard against brick exterior wall, has reached end of serviceable life. Unit assessed and documented with photographic records showing round-top condenser with radial fin pattern positioned on concrete pad with electrical disconnect box mounted on wall above. Presented replacement options for new energy-efficient central AC system to restore reliable cooling capacity.

Completed full installation of new Lennox air conditioning system including outdoor condensing unit and indoor evaporator coil. Relocated condensing unit to new position on concrete pad with proper clearances, installed refrigerant lines, condensate drainage, and electrical disconnect. System was evacuated, charged to manufacturer specifications, and tested with digital manifold gauges confirming proper refrigerant pressures of 194 PSIG on low side and 233.3 PSIG on high side with acceptable superheat and subcooling readings. Permit was requested for installation and electrician will be required for final electrical connections.

Provided estimate for replacement of non-operational air conditioning system and aging natural gas furnace located in basement. Existing furnace exhibits extensive rust and corrosion on exterior panels and blower compartment, indicating advanced deterioration and end of serviceable life. Current thermostat displaying abnormal reading requires replacement with new equipment installation.

Responded to no hot water complaint at 70-year-old residential property. Upon inspection of basement-installed tanked water heater, diagnosed failed pilot light assembly preventing burner ignition. Verified gas supply to unit, inspected thermocouple and pilot assembly for proper function. Relit pilot flame following manufacturer specifications, confirmed burner ignition cycle, and tested temperature and pressure relief valve operation. Verified all supply and return connections, expansion tank mounting, and flue venting integrity. Restored hot water service throughout residence.

Responded to service call for air conditioning unit check-up in basement location. Upon inspection, diagnosed locked compressor on unit less than one year old. Provided detailed replacement estimate for complete AC system due to compressor failure. Documented existing HVAC installation including ductwork configuration, refrigerant lines, and mechanical connections for replacement specifications.

Completed full HVAC system installation including a 70,000 BTU furnace and 2.5 ton air conditioning unit with rear discharge configuration. Successfully installed all equipment, connected refrigerant lines, performed system startup and diagnostics using refrigerant manifold gauges to verify proper pressures and operation. Permit requested for mechanical installation, and system qualified for utility rebate program under AHRI certification number 215663829.

Completed system start-up and commissioning of dual air handling unit installation in basement mechanical room. Verified proper operation of both units, inspected refrigerant line connections, confirmed condensate drain lines are properly installed with appropriate PVC piping and primer application, and documented system condition with approval sticker placement indicating successful installation inspection.

Completed installation of 3-ton rear-discharge air conditioning system with matching evaporator coil. System was reconnected, charged with refrigerant to manufacturer specifications, and tested using digital manifold gauges to verify proper operating pressures and temperatures across all parameters. New Lennox condensing unit was positioned on pad with proper clearances, 16x24x1 filter installed, and mechanical permit requested for compliance.

Completed comprehensive HVAC estimate for full system replacement on multi-unit residential building. System assessment revealed ZR-22 refrigerant system was completely empty, indicating major leak or component failure requiring full system replacement rather than repair. Documented existing exterior utility infrastructure including electrical metering and conduit configuration for proper system sizing and electrical load calculations, and photographed current Honeywell programmable thermostat for replacement specifications and compatibility requirements.

Completed comprehensive HVAC system estimate for full replacement of aging equipment including 7-10 year old furnace, 20 year old hot water tank, and air conditioning system. Evaluated existing ductwork configuration, thermostat functionality, and mechanical room layout to provide accurate quote for complete system installation scheduled for December 2nd timeframe.