Heating and Cooling Services in Southgate, MI

Completed comprehensive Gold membership furnace inspection on 13-year-old unit located in basement. Performed full system tune-up including visual inspection of all internal components, blower motor assembly, gas valve controls, electrical connections, and wiring harness. Verified proper operation of burner assembly, heat exchanger integrity, and ventilation systems. Tested safety controls, limit switches, and flame sensor functionality. Inspected and confirmed secure mounting of junction box and proper wire routing throughout cabinet. Examined condensate drainage system including hose connections and clamps for proper seal. All components found to be in good working condition with no deficiencies noted. System operating within manufacturer specifications with no repairs required at this time.

Responded to multiple cooling issue complaints and performed comprehensive system evaluation. Confirmed inadequate return air, which was contributing to reduced cooling performance. Verified thermostat operation showing system set to 71°F cooling setpoint with ambient temperature reading of 72.8°F. Conducted temperature measurements using calibrated instruments to assess system performance and airflow distribution throughout living spaces. Provided recommendations to improve return air pathways and optimize airflow for enhanced cooling efficiency.

Completed comprehensive Gold AC Inspection on 11-year-old air conditioning unit located in basement. Performed full system diagnostics including refrigerant levels, electrical connections, condenser and evaporator coil inspection, airflow measurements, and thermostat calibration. All components found to be operating within manufacturer specifications with no immediate service needs identified.

Completed comprehensive tune-up and city certification inspection on residential gas furnace system. Performed thorough inspection of all internal components including burner assembly with confirmed proper flame operation across all four burners, gas valve assembly with verified electrical connections, blower motor assembly, and PVC venting system. Inspected and evaluated thermostat operation, humidifier functionality, and hot water tank condition including pressure relief valve and copper supply lines. All systems found operating within normal parameters and documented with photographs for certification records.

Installed GFCI protection for outdoor electrical equipment including panel box, meter, and HVAC disconnect mounted on exterior brick wall. Verified proper grounding and functionality of all protected circuits, ensuring compliance with current electrical code requirements for exterior installations.

Completed comprehensive Gold AC Inspection on residential air conditioning system with equipment less than 10 years old and air handler located in basement. Performed full system evaluation including inspection of outdoor condensing unit, electrical disconnect box, and all associated components. Verified proper system operation, examined condensate drainage system, assessed electrical connections and service disconnect, and documented equipment condition through photographic records. All components found to be functioning properly with no deficiencies noted during inspection.

Responded to no hot water complaint in a 10-year-old residential property. Upon inspection, found an AO Smith tanked water heater in the basement with complete loss of hot water supply throughout the home. Documented existing installation with copper supply piping, brass shut-off valves, and proper venting configuration. Assessed unit condition, verified all safety labels and warning stickers were present and legible, and confirmed water heater was properly positioned on concrete floor against concrete block wall with appropriate clearances. Photographed the installation showing piping connections at top of unit including red and yellow-handled valves, metallic ductwork, and overall utility room setup for service records.

Completed comprehensive Gold AC Inspection on one-year-old Lennox outdoor condensing unit located in backyard. Performed full system evaluation including refrigerant charge verification, electrical component testing, condenser coil cleaning, and airflow assessment. All components operating within manufacturer specifications with no deficiencies noted; unit properly installed on pad with adequate clearance and insulated refrigerant lines secured to building exterior.

Completed comprehensive Gold AC inspection on a 3-year-old residential air conditioning system. Verified operational status of outdoor condenser unit and indoor thermostat controls, confirmed proper system functionality with equipment operating as designed. Performed standard preventive maintenance inspection protocol, documenting equipment condition through photographic records of the White-Rodgers programmable thermostat and exterior condenser unit with adequate clearance and airflow access.

Conducted comprehensive site assessment for complete HVAC system replacement in owner-occupied residence. Evaluated existing 21-year-old air conditioning unit located in basement mechanical room, documenting current system configuration including heat pump ductwork, humidifier component, and associated ventilation infrastructure. Photographed equipment layout, ductwork routing, and basement conditions to develop accurate replacement quote for whole system upgrade.

Completed comprehensive NSP AC inspection on single Bryant condensing unit with air handler located in basement. Inspected outdoor condenser unit positioned on concrete pad with proper clearance and landscaping maintenance, verified operational status of unit under 10 years old, examined evaporator coil and refrigerant line connections at indoor air handler, and provided complimentary air filters per maintenance agreement specifications.

Completed full HVAC system installation including 110,000 BTU gas furnace and 3.5 ton air conditioning unit with base and reconnection of electrical service. Mechanical and electrical permits were obtained prior to installation. System was commissioned with refrigerant pressures verified using diagnostic gauges, gas valve connections secured, and all electrical wiring completed per code requirements. DTE energy rebate documentation was processed for qualifying equipment.

Completed AC system startup in basement location. Performed operational testing of newly installed air conditioning equipment, verified proper condensate drainage and inspected drain pan for functionality. All systems operational and running within manufacturer specifications.

Conducted comprehensive site assessment for complete HVAC system replacement. Evaluated existing ductwork installation in basement mechanical room, documenting current system configuration including horizontal trunk lines, rigid metal transitions, and mounting hardware conditions. Photographed exposed ceiling joists, existing duct strapping, electrical panel locations, and available workspace for new equipment installation. Assessed structural support requirements and clearance specifications needed for proposed heating and cooling equipment. Provided detailed measurements and photographic documentation to prepare accurate full system replacement estimate.

Provided comprehensive estimate for complete HVAC system replacement of 35-year-old heating and cooling equipment in basement installation. Evaluated existing natural gas furnace and air conditioning system serving small residential space under 1500 square feet, assessed current ductwork configuration and electrical connections, and documented equipment specifications for replacement proposal.

Relocated air conditioning condenser unit to new position on exterior concrete pad. Reinstalled refrigerant line set through wall penetration with proper grommet and seal, performed system pressure test with manifold gauges, and verified unit operation at new location.

Installed GFCI protection for exterior HVAC system electrical components mounted on residential deck. Verified proper grounding and circuit protection for outdoor condenser unit, electrical disconnect, and associated conduit runs to ensure code-compliant operation in exterior environment.

Completed comprehensive Gold AC inspection on 12-year-old residential air conditioning system with outdoor condenser unit and basement-located air handler. Performed full system evaluation including refrigerant levels, electrical connections, condensate drainage, airflow measurements, and component functionality testing. Unit operating properly at time of inspection with condenser positioned on concrete pad with proper drainage and clearances maintained.

Completed comprehensive Gold AC inspection on 2023 air conditioning system with air handler located in basement and outdoor condenser unit positioned on concrete pad with decorative rock landscaping. Performed full system evaluation including visual inspection of condenser cabinet, fan assembly, and external components, confirming unit operational status and general equipment condition. Advised customer that area surrounding condenser requires clearing of debris and any animal waste to maintain proper airflow and system efficiency.

Completed comprehensive Gold AC Inspection on 7-year-old Daikin air conditioning system with outdoor condenser unit and attic-mounted air handler. Performed full system evaluation including refrigerant level check, electrical connection inspection, condensate drain verification, and filter assessment. All components operating within normal parameters; no deficiencies noted at time of service.