Heating and Cooling Trenton

Completed comprehensive tune-up and inspection on Bryant brand air conditioning system over 10 years old at mobile home residence. Outdoor condensing unit examined with focus on compressor operation, refrigerant levels, electrical connections, and condenser coil cleanliness. Verified proper function of condensate pump assembly mounted on exterior wall, checked drain line flow and pump operation. Indoor evaporator coil accessed in utility closet, inspected coil condition, refrigerant line connections including compression fittings and O-ring seals, and verified drain pan integrity. All components found operational, system running within normal parameters at time of inspection.

Completed comprehensive Gold-level furnace inspection on 10-year-old forced air heating system located in basement mechanical room. Performed thorough visual and operational assessment of furnace components including gas valve, ignition control module, heat exchanger, blower assembly, and all electrical connections. Inspected PVC venting system, refrigerant lines, and associated HVAC equipment. Verified proper furnace operation, checked all safety controls, examined wiring harnesses and control board functionality, and documented system condition with photographic records. All components found operating within normal parameters with no immediate repairs required.

Responded to water leak under bathroom sink with reported mold odor in residence. Upon arrival, water supply had already been shut off for two weeks by homeowner. Performed diagnostic inspection of under-sink plumbing assembly, which consisted of black PVC P-trap configuration with flexible braided supply lines connected to aged white PVC supply pipes emerging from floor. Identified water damage and moisture staining on hardwood flooring surrounding pipe penetrations, along with mineral deposits and residue buildup at pipe bases. Observed deteriorated wallpaper and debris accumulation in affected area. Documented existing conditions including compromised shut-off valves with brass compression fittings and signs of prolonged moisture exposure on surrounding surfaces.

Performed comprehensive tune-up on 21-year-old HVAC system located in basement. Inspected and documented condition of metal mesh filter showing some discoloration and accumulation of debris. Conducted electrical diagnostics using UEi DL389B multimeter, measuring voltage readings of 83.1V and 81.0V. Completed standard inspection of humidifier, thermostat, and hot water tank as part of maintenance service.

Responded to a gas leak issue in a 3-month-old furnace after utility company detection. Inspected the furnace located in hallway and identified leaking pipe connections with inadequate thread sealant. Repaired by applying proper pipe dope to cast iron fittings and conducted pressure testing to verify resolution of the gas leak.

Conducted assessment of 26-year-old York furnace with improper repair work performed by previous company. Identified damaged ignitor mounting bracket (now obsolete) and incorrectly installed "hot rod" ignitor incompatible with this model. Presented replacement options for both furnace-only and complete furnace/AC system replacement to address reliability concerns with aging equipment.

Performed diagnostic testing on 18-year-old furnace that was not operating properly. Combustion analysis with Bacharach analyzer revealed CO levels at 92 ppm (later measured at 57 ppm) with 88.6% efficiency and stack temperature of 136°F. Completed necessary repairs to restore safe and reliable heat operation.

Completed Gold Boiler Inspection on steam heating system under 10 years old. Conducted combustion analysis using Bacharach analyzer, recording stack temperature of 316°F, CO2 at 8.3%, excess air at 37.1%, and CO levels at 51 ppm. System is operating within acceptable parameters with no immediate concerns identified.

Conducted inspection of 27-year-old counterflow HVAC system. Furnace exhibited fracture formation with dark rust spot, oil leakage from blower motor, and inducer motor operating at maximum rated amperage. AC system uses R22 refrigerant with documented low charge from previous service. Recommended complete system replacement due to advanced age, deteriorating conditions, and compatibility requirements of counterflow configuration.