Heating and Cooling Clarkston

Installed new kitchen faucet and battery backup sump pump system per approved estimate. The backup pump installation included proper PVC discharge piping configuration with check valves and connection to existing primary sump pump basin to provide emergency drainage protection during power outages.

Completed comprehensive tune-up inspection on a 2-year-old residential furnace located in basement. Performed thorough examination of all major components including blower motor assembly, burner assembly with flame sensors, heat exchanger, electrical connections, and control board wiring. Inspected evaporative cooler pad within the system, noting mineral deposits and dust accumulation on the honeycomb cellulose media, which is typical for units in service. Verified proper operation of gas valve controls, checked all wire connections for secure placement, and examined PVC venting system for proper installation. All safety controls, limit switches, and flame sensors tested and functioning within manufacturer specifications. System operational and ready for heating season.

Coordinated with Independence Township for city water shut-off and restoration. Replaced second-floor toilet with ADA-compliant elongated white toilet, including new stop valve, supply line, and escutcheon for 1/2" copper straight connection. Removed and replaced drop-in utility sink with new unit, installed new stop valves and customer-supplied faucet, connected to existing drain line, and tested for proper operation. Rebuilt water meter assembly with new #1 and #2 meter valves, replaced SharkBite irrigation valve, and tied into existing riser. Installed expansion tank at water heater with copper piping connections and proper mounting. Inspected and addressed leaking kitchen faucet. All fixtures tested and verified operational upon completion.

Provided quote for electrical outlet replacement in finished living area and installation of light fixture in unfinished basement space with exposed framing. Assessment included evaluation of existing electrical infrastructure, including conduit routing through wall studs and proximity to HVAC ductwork in basement area.

# Plumbing Service - Toilet/Urinal Responded to service call for reported toilet issue on second floor of 26-year-old residential property. Upon arrival, conducted comprehensive plumbing system inspection to diagnose the problem. Investigation revealed that the reported toilet concern was not the primary issue requiring attention. During diagnostic evaluation, discovered significant concerns with the water heater system located in the basement utility area. Identified water staining and discoloration on concrete floor surrounding water heater base, indicating active or previous moisture infiltration. Observed aged copper supply piping with visible tarnishing and oxidation throughout the plumbing assembly. Documented deteriorating wall conditions adjacent to water heater installation, with vertical cracking visible on painted surface. Noted presence of collection cup positioned beneath lower pipe connections, suggesting known or suspected drip issues. Examined pressure relief valve a

Responded to no cooling condition with outdoor condenser unit not operating while indoor blower continued to run. Performed diagnostic evaluation of split system air conditioning equipment and determined condenser failure required full system replacement. Completed installation of new HVAC system including outdoor condensing unit and indoor air handler with associated refrigerant lines, electrical connections, and ductwork integration in basement mechanical space.

Responded to service call for 5-year-old AC unit located above garage that was not coming on at all. Diagnosed and repaired electrical issue preventing system operation. Performed maintenance on both AC units as requested, including inspection of outdoor electrical components, conduit connections, and refrigerant lines.

Completed comprehensive Gold AC Inspection and yearly maintenance on residential cooling system with outdoor condenser unit located on exterior concrete pad and indoor components in basement. Performed full system evaluation including refrigerant level check, electrical connection inspection, condensate drain line assessment of PVC drainage system, coil cleaning, and operational testing of all components. Unit found in good working condition with no deficiencies noted; system operating within manufacturer specifications and ready for cooling season.

Completed comprehensive Gold AC Inspection on 8-year-old Bryant air conditioning system with outdoor condenser unit and basement-located air handler. Performed standard preventive maintenance procedures including visual inspection of condenser coils, refrigerant lines, and overall unit condition. All components found operating within normal parameters with no immediate service needs identified at time of inspection.

Responded to active leak under kitchen sink in 26-year-old residential property. Upon inspection, identified compromised connection at garbage disposal drain assembly and deteriorated P-trap seal causing water intrusion into cabinet base. Disassembled existing drain configuration, replaced P-trap assembly with new PVC components, and re-secured disposal discharge connection with proper gasket seal. Tested all connections under full water pressure to verify leak elimination. Additionally, installed new quarter-turn shutoff valves in basement to replace original gate valves showing age-related wear. All plumbing fixtures tested and confirmed operational with no additional leaks detected throughout property.

Completed prepaid maintenance visit and documented existing HVAC equipment for customer requesting quote on two Nest thermostat installations. Inspected outdoor condensing units, both under 10 years old, and photographed equipment configuration including evaporator coil location in basement for estimate preparation.

Completed comprehensive Gold AC Inspection on 12-year-old Lennox HVAC system located in basement. Performed full system evaluation including inspection of air handler, evaporator coil, condensate drainage, electrical connections, and refrigerant lines. Examined and documented air filter condition, noting pleated filter media with accumulated dust and particulate matter requiring replacement. Verified proper operation of all system components, checked airflow, and confirmed equipment is functioning within normal parameters. System operational and homeowner advised of maintenance findings.

Completed scheduled maintenance on an 11kW Honeywell standby generator per maintenance plan requirements. Performed comprehensive inspection of all internal components including air filtration system, control modules, battery systems, and electrical connections. Verified proper operation of all mechanical systems, checked fluid levels, and documented equipment condition through photographic records.

Completed comprehensive Gold AC Inspection on a 10-year-old residential air conditioning system with air handler located in basement. Performed multi-point inspection of outdoor condenser unit and verified system operational status, confirming unit is functioning properly with adequate clearance around exterior equipment.

# Job Description Successfully installed a new 50-gallon battery backup water heater system in the customer's utility room. The installation included complete connection of copper supply lines, gas line hookup, pressure relief valve installation, proper venting configuration, and secure mounting with metal strapping to ensure code compliance and safe operation. All plumbing connections were tested for leaks, the unit was fired up and verified operational, and the battery backup system was installed and tested to ensure continued hot water availability during power outages.

Diagnosed and confirmed leaking water heater installed in 2022 (originally replaced under warranty from 2017 unit). Documented current leak condition on main level tank which remains under manufacturer warranty until 12/11/2027. Took photographic evidence of installation environment showing water heater with copper piping and unfinished surrounding area for warranty claim processing.

Performed an assessment for a battery backup sump pump installation. Inspected existing ceiling damage and plumbing infrastructure, noting significant water damage and an exposed electrical fixture through a ceiling opening. Examined the current sump system connection point with PVC piping and valve assembly to determine appropriate backup system specifications.