Heating and Cooling Harper Woods

Completed comprehensive tune-up and city certification inspection on 3-year-old forced air furnace located in basement. Performed full system evaluation including burner assembly inspection, confirmed proper ignition sequence and flame characteristics showing consistent blue flame across all burner ports, verified all electrical connections and wiring integrity, and tested safety controls. Informed customer that cold air return capping falls outside our scope of service as we do not perform ductwork modifications.

Completed full HVAC system installation in basement mechanical room, including 70,000 BTU furnace, 2-ton air conditioning unit, programmable thermostat, humidifier, and condensate pump. Installed new ductwork with metallic flexible and rigid connections from air handler to ceiling distribution points. Ran electrical wiring and mounted control components on furnace unit. Connected condensate pump with drainage lines and performed system flush. Secured mechanical and electrical permits prior to installation. Reconnected all utility connections and tested system operation to verify proper heating and cooling functionality.

Completed comprehensive full system HVAC estimate for residential property with existing Lennox air conditioning condenser unit installed on exterior brick wall. Documented current equipment condition, photographed installation site including outdoor unit placement and surrounding area, and assessed system requirements for potential replacement or upgrade recommendations.

Completed comprehensive inspection and full system estimate for 26-year-old furnace located in basement. Evaluated existing Bryant humidifier unit, ductwork configuration, control systems, and thermostat operation. Assessed outdoor condensing unit condition with protective cover in place on gravel pad adjacent to foundation. Documented all system components including electrical connections, duct insulation, and overall equipment condition to provide complete replacement recommendations for aging HVAC system.

Completed full HVAC system replacement including installation of 70,000 BTU furnace and 2-ton air conditioning unit in rear yard location. Installed new Honeywell digital thermostat, humidifier, and condensate pump with proper PVC drainage piping routed along exterior brick wall. Reconnected all electrical and mechanical components, obtained mechanical and electrical permits, and verified system operation with thermostat displaying proper cooling function.

Completed comprehensive Gold-level furnace inspection on forced-air heating system located in basement. Performed visual examination of all internal components including burner assembly with multi-port configuration, ignition system with operational LED indicators, blower motor assembly, and electrical wiring harnesses. Verified proper operation of all mechanical and electrical systems, documented equipment condition through photographic records, and confirmed unit is functioning within normal operating parameters.

Conducted comprehensive inspection and assessment of 20-year-old Amana furnace system located in basement for certificate of occupancy requirements. Evaluated existing HVAC equipment including furnace unit, ductwork connections, humidifier, thermostat, and hot water tank to determine system condition and replacement needs. Documented current installation featuring cream-colored Amana furnace with galvanized metal ductwork, flexible duct connections, and electrical panel configuration to provide detailed replacement estimate for aging equipment prior to property sale.

Performed comprehensive HVAC inspection for certificate of occupancy on 20-year-old system located in basement. Conducted temperature measurements across heat exchanger coils, verified proper operation of blower motor assembly, and inspected all electrical connections. Inspection included complete evaluation of humidifier, thermostat functionality, and hot water tank, with all components found to be operating within acceptable parameters for certification requirements.

Completed comprehensive tune-up and city certification inspection on 10-year-old furnace system located in basement. Performed full system evaluation including burner assembly, blower motor operation, electrical connections, and safety controls. Inspected and tested humidifier, thermostat functionality, and hot water tank as part of certification requirements. All components found operating within manufacturer specifications, unit approved for city certification required for property sale.

Performed comprehensive evaluation of 20-year-old air conditioning system located in basement following customer report of inadequate cooling performance and suspected refrigerant deficiency. Conducted thorough inspection of existing HVAC infrastructure, including aged galvanized ductwork showing significant weathering and surface deterioration, assessed overall system condition and capacity. Provided full system replacement estimate based on equipment age, current performance issues, and observed wear on distribution components to ensure optimal cooling efficiency and reliability.

Responded to no cooling complaint on 20-year-old AC unit located in basement. Upon arrival, inspected control board assembly and electrical components for proper operation. Utilized clamp meter to perform diagnostic testing, measuring voltage and amperage readings on system circuits. Control board showed signs of age with visible discoloration on components. Checked all wire connections at terminal blocks and verified proper control signals. Evaluated refrigerant charge levels and overall system performance to determine root cause of cooling deficiency.

Responded to service call for water leak near basement furnace with water accumulation around the unit. Conducted comprehensive system assessment of forced air HVAC system estimated to be 10+ years old. Inspected outdoor condensing unit, verified electrical connections at main panel including dedicated circuits for air conditioner and furnace, and documented equipment conditions to provide full system replacement estimate due to age and existing leak issue.

Responded to service call for water leak near basement furnace with visible water accumulation around the forced air unit. Upon inspection, identified the source as condensate drainage issue from the HVAC system. Cleared blocked condensate drain line, verified proper drainage flow, and confirmed outdoor condenser unit was operating correctly with no refrigerant leaks. Tested system operation and ensured all water had been properly removed from around the furnace area to prevent further damage.

Responded to kitchen sink leak complaint at residential property. Upon inspection, identified leak source and assessed water supply line connections in utility area. Inspected copper piping, shutoff valves, and plumbing infrastructure to ensure proper function and verify no additional leaks were present in the system.

Responded to no cooling complaint on 5-year-old residential air conditioning system. Performed diagnostic evaluation of outdoor condenser unit located at basement level. Utilized digital manifold gauges to measure system pressures and assess refrigerant charge levels. System inspection revealed operational deficiencies requiring technical assessment of compressor function, refrigerant flow, and electrical components to determine root cause of warm air discharge from indoor unit.

Performed boiler inspection on approximately 10-year-old unit located in laundry room on main floor. Upon testing, detected high carbon monoxide levels and immediately shut down boiler for safety. Documented existing system including circulation pump, piping configuration, and water heater assembly. Provided estimate for necessary repairs or replacement to address dangerous CO condition and restore safe heating operation.

Responded to a broken pipe issue in the bathroom shower/tub area that had been ongoing for seven days. Accessed the affected plumbing through cabinet and wall openings to locate and assess the damaged pipe. Repaired the burst pipe, verified proper water flow and pressure, and confirmed no additional leaks throughout the system.

Completed comprehensive boiler inspection on 10+ year old unit located in main floor laundry room. Performed standard tune-up procedures including visual examination of electrical controls, junction box, and associated wiring; inspected all plumbing connections, supply valves, and piping infrastructure for proper operation and potential leaks; verified system safety controls and operational functionality. Unit found to be operating within normal parameters with no immediate service needs identified at time of inspection.

Responded to service call for furnace cutting out on limit switch requiring multiple resets to reach set point. Performed diagnostic evaluation on outdoor HVAC system. Pumped down air conditioning unit and recovered refrigerant as previously arranged. Evacuated system using vacuum pump and verified proper vacuum levels. Recharged system with 2 pounds of R-410A refrigerant to manufacturer specifications. Tested system operation and verified proper pressures and temperatures using digital manifold gauges. Unit operating within normal parameters upon completion.

Conducted on-site assessment for air conditioning unit replacement. Evaluated existing HVAC system installation located in mechanical space, including air handler unit with associated ductwork and electrical connections. Inspected electrical panel to verify circuit breaker capacity and available power supply for potential new equipment installation. Documented current system configuration, including insulated supply ductwork, PVC condensate drain lines, and flexible return air connections. Photographed electrical infrastructure and existing HVAC components to provide accurate equipment specifications and installation requirements for replacement estimate.