Heating and Cooling Services in West Bloomfield Township

Responded to a non-draining sink that had been previously snaked 20 feet with no lasting results. Upon inspection, identified the issue as a sump pump drainage system with potential backup concerns in the basement utility area. Assessed the copper piping configuration, sump pump basin, and discharge lines connected to the drainage system. Cleared the obstruction and verified proper water flow through the sump pump discharge to restore full drainage functionality.

Conducted on-site evaluation for non-operational air conditioning system and hot water heater replacement estimate. Assessed existing HVAC equipment location, ductwork configuration, and utility connections including natural gas or LP fuel source availability. Documented current system conditions through photographic inspection, noting equipment access points, thermostat location, and potential installation considerations for complete system replacement. Discussed additional water filtration options with property contact to provide comprehensive estimate for multiple equipment upgrades.

Provided comprehensive estimate for complete Lennox HVAC system replacement including furnace and air conditioning unit for 20+ year old equipment currently located in basement. Existing units remain operational but have exceeded recommended service life, prompting evaluation for full system upgrade to improve efficiency and reliability.

Responded to no cooling complaint on 5-year-old residential AC system located in basement. Upon arrival, found indoor blower motor inoperative and evaporator coil frozen with ice buildup on refrigerant lines. Verified thermostat was calling for cooling and set to 80 degrees. Turned system off to allow coil to thaw completely. Inspected blower motor and found failed capacitor preventing motor operation. Replaced defective capacitor with proper OEM replacement. Once coil fully thawed, tested blower motor operation and confirmed proper airflow across evaporator coil. Checked refrigerant lines for proper insulation and verified no restrictions in ductwork. Cycled system through complete cooling cycle and monitored for proper operation. System restored to normal cooling operation with adequate airflow and no further freezing issues detected.

Returned to site with second technician to replace all four quick connect fittings on the outdoor condensing unit. Installed two 3/8" flare nuts and two 1/4" flare nuts to restore proper refrigerant line connections. System pressure tested and verified operational upon completion.

Responded to service call for non-functioning garbage disposal unit. Upon inspection, assessed the existing black garbage disposal mounted beneath kitchen sink and evaluated electrical connections and plumbing configuration. Documented current installation including disposal unit, electrical wiring, PVC P-trap assembly, and drain connections for service records. Determined operational status of unit and provided recommendations for repair or replacement options to restore functionality to kitchen waste disposal system.

Completed gas line estimate for customer's property. Inspected and photographed existing gas piping system routed through attic space, including black iron pipe with proper support brackets and connections. Evaluated mechanical room area containing HVAC equipment, flexible white tubing, and associated components. Documented current installation conditions including pipe routing, structural penetrations, ventilation ductwork, and equipment placement to provide accurate scope and pricing for proposed gas line work.

Performed diagnostic camera inspection of drain line to assess potential repairs needed. Lifted, scoped, and reset toilet in bathroom with terra cotta speckled tile flooring to access drain system. Camera inspection completed to evaluate interior condition of drainage piping and identify any blockages, damage, or structural issues requiring remediation.

Completed scheduled maintenance on a Honeywell 10kW standby generator. Performed standard preventive maintenance procedures including inspection of all critical components, fluid level checks, battery testing, and operational verification. Unit is operating within normal parameters and homeowner renewed their generator maintenance plan.

Responded to no cooling complaint on 6-year-old residential air conditioning system. Upon arrival, confirmed outdoor unit was running but indoor airflow was room temperature with no refrigerant cooling effect. Diagnosed failed compressor contactor preventing compressor operation while condenser fan motor continued to run normally. Replaced defective contactor, restored power to compressor, and verified proper system operation with adequate cooling and correct amperage draw. System returned to normal cooling capacity with whole home comfort restored.

Completed comprehensive Gold Furnace Inspection on forced air heating system located in main floor utility room with easy access. Performed full system evaluation including visual inspection of all major components, gas valve assembly, electrical connections, and control mechanisms. Unit is operational with no immediate concerns identified at time of inspection.

Responded to customer complaint of inadequate cooling on second floor of two-story residence, with upper level measuring 3-4 degrees warmer than first floor. Performed diagnostic evaluation of 4-year-old A/C system located in backyard, including inspection for closed dampers and obstructed venting. Conducted static pressure readings across the ductwork to assess airflow distribution and identified airflow deficiency to upper level. Evaluated home construction, insulation configuration, and attic accessibility to determine factors contributing to temperature imbalance. Documented conditions in second-floor bedrooms showing reliance on portable fans for supplemental cooling. Assessed floor register placement and output in affected rooms to verify inadequate conditioned air delivery to upper level zones.

Completed Gold AC Inspection on 7-year-old air conditioning and furnace system located in basement. Performed comprehensive inspection of outdoor condenser unit, which showed normal weathering and surface discoloration consistent with age and outdoor exposure. Verified fan operation, checked protective grille security, and assessed overall unit condition. Inspected all accessible components per Gold maintenance protocol to ensure system is operating within manufacturer specifications.

Responded to recurring sediment backup in basement shower drain that had been previously snaked approximately one year ago. Upon inspection of the basement utility area and plumbing system, assessed the drainage infrastructure and water supply configuration to determine if the issue extended beyond a simple blockage requiring standard augering procedures. Evaluated the plumbing layout, including connections near the water heater and associated piping, to identify potential causes of persistent sediment accumulation and backup conditions affecting the shower drain performance.

Provided quote for installation of gas line to supply kitchen appliances. Assessed existing utility area and plumbing infrastructure to determine optimal routing for new gas piping. Documented current conditions including location of existing drainage systems, structural supports, and available pathways for gas line installation.

Conducted assessment of aging boiler system located in basement with multiple zone piping configuration. Evaluated existing heating system previously serviced in spring, documented current condition of boiler unit and associated distribution piping with red-handled zone valves. Provided replacement estimate for standard gas-fired boiler per customer preference, excluding electric boiler options as requested.

Completed comprehensive tune-up service on a 5-year-old residential air conditioning system with outdoor condenser unit located on covered patio area. Performed standard maintenance protocol including inspection of condenser coils, cleaning of exterior surfaces, verification of refrigerant levels, and assessment of fan operation and electrical connections. Customer enrolled in Gold Plan preventative maintenance program during service visit.

Completed comprehensive Gold AC Inspection on a multi-unit residential HVAC system with equipment over 10 years old. Inspected basement-located furnace/air handler unit with control panel, verified proper operation of digital displays and indicator lights, and examined associated copper refrigerant lines, shut-off valves, and expansion tank connections. Evaluated attic-mounted air handler unit with control interface, assessed flexible ductwork connections, inspected PVC condensate drainage lines and mounting brackets, and verified proper installation of electrical connections. Both systems confirmed operational with no immediate service needs identified during inspection.

Conducted comprehensive evaluation of residential cooling system due to insufficient cooling performance. Assessed outdoor air conditioning condenser unit and indoor Payne furnace with coil assembly located in basement, both components showing signs of age at 10+ years of service life. Provided detailed replacement estimate for complete HVAC system upgrade to restore optimal cooling capacity and efficiency.

Responded to low water pressure complaint affecting entire residence. Upon inspection of water filtration system in crawl space, confirmed water filter cartridge was cross-threaded in housing, restricting flow throughout plumbing system. Removed improperly installed filter cartridge from transparent housing unit connected to main water line and blue pressure tank assembly. Cleaned housing threads to ensure proper sealing, installed new filter cartridge with correct threading and torque specifications, and verified all connections were secure. Tested system operation and confirmed full water pressure restoration to all fixtures throughout home.