Heating and Cooling Grosse Pointe Woods

Completed installation of two furnace units and one water heater system in residential basement utility space. Mounted gray metal air handler unit to ceiling using reinforced metal brackets with reflective insulation wrapping for thermal efficiency. Installed white PVC condensate drain lines from equipment along wall to proper drainage point. Routed black flexible electrical conduit and silver metallic insulated supply ductwork from units to existing distribution system. Secured all ductwork and piping with appropriate metal clamps and straps per code requirements. Verified proper clearances around equipment for service access and safety compliance. System tested and operational upon completion.

Completed annual Gold Plan maintenance on Lennox air conditioning system with no reported issues. Performed comprehensive tune-up including inspection of outdoor condensing unit, verified thermostat operation displaying 74°F, checked electrical connections and disconnect components, and assessed overall system performance. Unit operating within normal parameters with all components functioning properly.

Responded to service call for water leak from 14-year-old furnace located in attic causing system shutdown. Inspected unit and identified failed secondary heat exchanger as source of condensate leak. Ordered replacement secondary heat exchanger from manufacturer for pickup and scheduled installation. Performed visual inspection of primary heat exchanger for cracks and structural integrity during diagnostic evaluation.

Responded to no-cooling call on recently installed air conditioning system in two-story condo unit. Upon arrival, performed diagnostic evaluation of one-year-old outdoor condenser unit. Inspected fan assembly, wire guard, and cabinet housing—all components appeared clean and well-maintained with no visible damage or deterioration. System had operated properly the previous day but ceased functioning completely. Documented unit condition with photographs showing intact fan blades, secure wire guard, and proper mounting on concrete pad. Completed troubleshooting procedures to identify cause of system failure and restored cooling operation to the residential air conditioning system.

Responded to service call for non-operational air conditioning system at residential property. Upon inspection, identified R-22 refrigerant system with low charge levels affecting both outdoor condenser unit located in backyard and indoor Amana air handler in basement. Due to age of equipment, refrigerant type, and system condition, provided comprehensive estimate for complete HVAC system replacement including new outdoor condensing unit and compatible indoor equipment.

Performed scheduled maintenance on a 16kW Honeywell residential generator. Discovered and documented severely corroded battery terminal connections exhibiting heavy oxidation and rust buildup that could compromise system reliability. Cleaned corroded terminals, inspected electrical connections, and completed standard preventive maintenance protocol to ensure proper generator operation.

Completed scheduled tune-up on 1-year-old Lennox furnace and AC system located in basement. Replaced furnace and AC filter with highest-rated filter available per customer request, as previous filter was heavily soiled requiring quarterly replacement schedule. Performed full system inspection with no operational issues found. Discussed air purifier options with customer for future consideration.

Responded to service call for A/C system evaluation. Upon inspection, identified electrical issue requiring specialist attention at main breaker panel serving AC units 1 and 2. Documented electrical panel conditions with photos showing main breaker box and AC circuit locations. Coordinated with electrical contractor for follow-up service to address breaker concerns and ensure safe system operation.

Responded to City of Grosse Pointe Woods code violation regarding improper water heater vent connection slope. Upon inspection, confirmed the hot water tank vent pipe was sloped in the incorrect direction, failing to meet minimum code requirements of 1/4 inch per foot pitch. Disconnected and repositioned the vent connection to ensure proper upward slope away from the A.O. Smith water heater, allowing condensation to drain back toward the appliance and exhaust gases to vent efficiently. Verified correct pitch using level and secured all connections. System tested and brought into compliance with municipal plumbing codes.

Supervisor returned to locate refrigerant leak in A/C system. Inspection revealed significant corrosion and oxidation on copper refrigerant lines with visible surface deterioration and mineral deposits at connection points. Documented corroded piping components and deteriorated fittings with photographic evidence for further assessment and repair recommendations.

Replaced failed compressor on residential outdoor condensing unit located in side yard between fences. Unit was accessed, top cover removed, and defective compressor was replaced with warranty part. Refrigerant lines were properly connected to new compressor, electrical connections were secured, and system was reassembled. Labor-only repair completed as compressor component was covered under existing parts warranty.

Responded to service call for Rheem tanked water heater experiencing operational issues for approximately 30 days in residential basement. Performed comprehensive diagnostic inspection of unit, examining all plumbing connections, gas line integrity, temperature and pressure relief valve, thermostat operation, and burner assembly. Identified and resolved the malfunction, tested system for proper heating cycle and temperature output, and verified all safety controls were functioning correctly. Unit restored to full operational status with no leaks detected at copper pipe connections or gas line fittings.

Responded to no-cooling complaint on residential air conditioning system with outdoor condenser unit in backyard and air handler in basement. Upon inspection, verified thermostat was set to OFF mode with indoor temperature reading 78°F. Checked refrigerant line connections at basement air handler penetration point and confirmed proper installation of suction and liquid lines with intact insulation. Instructed homeowner on proper thermostat operation and system controls. System operational upon departure with no mechanical defects identified.

Completed comprehensive Gold AC Inspection on 4-year-old system with air handler located in basement. Performed full multi-point inspection including refrigerant levels, electrical connections, condensate drainage, and airflow measurements. Inspected Aprilaire humidity control system and noted accumulated dust on unit, indicating need for routine cleaning. Observed Rheem Professional Series water heater in mechanical room with dust accumulation on top of tank and copper piping connections. Advised homeowner that replacement air filters are needed for optimal system performance and efficiency.

Responded to service call for inoperative garbage disposal unit. Upon arrival, inspected undermount stainless steel sink with disposal assembly and confirmed unit had completely ceased operation. Diagnosed electrical and mechanical failure, performed necessary repairs to restore full functionality to the disposal system.

Performed routine maintenance on a 16kW Generac standby generator. Conducted comprehensive inspection of unit including visual examination of exterior panels, control systems, and electrical connections. Verified generator operational status and documented equipment condition through photographic records. Unit found to be functioning properly at time of service.

Completed full HVAC system replacement including installation of 70,000 BTU Lennox furnace and 2-ton air conditioning unit in rear yard location. Installed new thermostat, humidifier, and reconnected existing condensate pump. Ran new ductwork and configured system per AHRI certificate 215663106 specifications. Obtained mechanical and electrical permits prior to installation. System tested and verified operational upon completion.

Completed comprehensive Gold AC Inspection on residential air conditioning system less than 10 years old with outdoor condenser unit located on concrete pad against exterior brick wall. Performed full system evaluation including visual inspection of condenser unit showing normal weathering, verified refrigerant line insulation and electrical disconnect box condition, checked unit placement and clearances around landscaping, and documented equipment condition through photographic records. All components inspected per gold maintenance protocol with system operating within normal parameters.

Removed 3-4 year old furnace and air conditioning system from basement to allow for waterproofing work. Upon completion of waterproofing, reinstalled both units to basement location, reconnected refrigerant lines and electrical connections, and verified proper system operation. All equipment returned to full functionality with no issues noted.

Responded to no cooling complaint on 2-year-old residential AC system affecting entire home. Upon arrival, performed complete system diagnostic including visual inspection of outdoor Lennox condenser unit and indoor furnace/air handler in basement. Condenser unit appeared in good physical condition with clean coils and proper clearances; both copper refrigerant lines showed appropriate insulation with no visible damage or refrigerant leaks at service valves. Verified power supply to both indoor and outdoor units, checked thermostat operation and settings, and measured system pressures and temperatures. Indoor unit connections, electrical components, and ductwork inspected without abnormalities noted. System successfully restored to proper cooling operation and tested through complete cycle to verify adequate airflow and temperature differential across evaporator coil.